8-11
–+
ELEC
E
IGNITION SYSTEM
1. Measure:
● CDI unit output (test #1)
Beyond specification → Replace igni-
tion coil.
Below specification → Measure
charge coil output.
Repeat checking two times.
CDI output:
125 V @ cranking
140 V @ 1,500 r/min
110 V @ 3,500 r/min
Measuring steps:
● Disconnect the ignition coil couple.
Connect the 3 pins test harness.
3 pins test harness:
YB-06443, 90890-06757
● Connect the tester to the measurement
terminal.
● Set the tester dial to specification.
Range:
● Crank or start the engine.
V
—
.......
2. Measure:
● Charge coil output (test #2)
Below specification → Replace charge
coil.
Beyond specification → Measure
pulser coil output.
Charge coil output:
(Br – L) 145 V @ cranking
160 V @ 1,500 r/min
130 V @ 3,500 r/min
Measuring steps:
● Connect the tester to the charge coil.
● Set the tester dial to specification.
Range:
● Crank or start the engine.
V
—
.......
Commentaires sur ces manuels