3-7
INSP
ADJ
E
OIL INJECTION SYSTEM/
POWER TRIM AND TILT SYSTEM
2. Adjust:
● Oil pump link joint position
POWER TRIM AND TILT SYSTEM
Power trim and tilt fluid
1. Check:
● Fluid level
Fluid level is low → Fill.
WARNING
To prevent the hydraulic fluid from spurt-
ing out by cancelling the internal pressure,
the PTT unit should be kept fully tilted up
(the tilt rod being fully lengthened).
2. Fill:
● Yamaha power trim and tilt fluid
Checking steps:
● Fully open the carburetor throttle
valve.
● Check the clearance a between the oil
pump lever and full open side stopper.
Adjustment steps:
● Loosen the lock nut.
● Remove the oil pump link joint at the
pump.
● Fully open the carburetor throttle
valve.
● Set the oil pump lever 1 mm off the full
open side stopper.
● Adjust the position of the link joint
until its hole aligns with the oil pump
set pin.
● Connect the link joint.
● Check that the throttle valve opens
fully.
● Tighten the lock nut.
● Install the washer and clip.
Checking steps:
● Tilt up the outboard, and lock it with
the tilt lock lever.
● Remove the plug screw.
● Check that the fluid level is immedi-
ately below the fluid hole.
T
R
.
.
Plug screw:
7 Nm (0.7 m • kg, 5.1 ft • lb)
Commentaires sur ces manuels