8-10
–+
ELEC
E
IGNITION SYSTEM
IGNITION SPARK GAP
WARNING
● While checking the spark be careful not to
touch any connection of lead wires of the
“Ignition spark gap tester”.
● When doing the spark test, take special
care not to allow leakage from the plug
cap which has been removed.
● This check is likely to produce sparks, so
be sure that no flammable gas or fluid is
present.
1. Check:
● Ignition spark gap
Out of specification → Replace.
CDI SYSTEM PEAK VOLTAGE
WARNING
While taking CDI unit check be careful not
to touch any connection of lead wires of
the “Digital tester”.
NOTE:
● If there is no spark, or the spark is weak,
continue with the CDI test.
● If a good spark is obtained, the problem is
not with the CDI system, but possibly the
spark plug or other component is defec-
tive.
Spark gap:
9 mm (0.35 in)
Checking steps:
● Adjust the spark gap to specification
by turning the adjusting knob.
Spark gap tester:
YM-34487/90890-06754
● Connect the spark plug cap to the
spark gap tester.
● Remove the spark plugs from the
engine.
● Crank the engine and check the sparks
from the ignition system through the
discharge window.
Commentaires sur ces manuels