Yamaha H11 Manuel du propriétaire télécharger pdf (Page 51)

ENGLISH

Keyboard Stand Assembly

H11 Owner’s Manual

6. Install the pedal structure.

6-1 Remove the covers from the grooves on the bot-

tom surface of A.

6-2 Align the pedal power cords (that come out from

the pipes of D) along with the grooves on the bot-

tom surface of A.

6-3 Align the holes on the bracket of D with the holes

on A, then attach D to A by tightening four long

screws (6×30 mm).

CAUTION

Be careful not to pinch the cords between the bracket and

the surface of A.

7. Connect the cords.

7-1 Connect the pedal cord plug to the pedal connec-

tor in the correct orientation.

7-2 Set the voltage selector to an appropriate voltage.

7-3 Connect the power cord plug to the power con-

nector in the correct orientation.

Voltage Selector

Before connecting the AC power cord, check the

setting of the voltage selector which is provided in

some areas. To set the selector for 110V, 127V,

220V or 240V main voltages, use a “minus”

screwdriver to rotate the selector dial so that the

correct voltage for your region appears next to the

pointer on the panel. The voltage selector is set at

240V when the unit is initially shipped. After the

proper voltage has been selected, connect the AC

power cord to the AC IN and an AC wall outlet. A

plug adaptor may be also provided in some areas

to match the pin conﬁguration of the AC wall

outlets in your area.

8. Replace the groove covers.

8-1 Insert the pedal cord and power cords into the

grooves securely, then attach the groove covers.

Correct

Incorrect

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 65 66

Pas de commentaire

Yamaha H11 Manuel du propriétaire Page 51