Yamaha H11 Manuel du propriétaire Page 15
- Page / 66
- Table des matières
- DEPANNAGE
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
ENGLISH
Before Using the H11
H11 Owner’s Manual
15
Connecting the Power Cord
Carefully read the following instructions and warnings before
connecting the power cord.
1. Connect the supplied power cord to the [AC IN] connector
on the instrument’s bottom panel. For an illustration of the
location of the [AC IN] connector, see “Panel Controls and
Te r minals” (page 10).
2. Connect the other end of the power cord to an AC outlet.
Make sure your H11 meets the voltage requirement for the
country or region in which it is being used.
In some areas, a plug adaptor may be provided to match the
pin configuration of the AC wall outlets in your area.
WARNING
Make sure your H11 is rated for the AC voltage supplied in the area in which it is to be used (as listed
on the bottom panel). Connecting the unit to the wrong AC supply can cause serious damage to the
internal circuitry and may even pose a shock hazard!
WARNING
Use only the AC power cord supplied with the H11. If the supplied cord is lost or damaged and needs
to be replaced, contact your Yamaha dealer. The use of an inappropriate replacement can pose a fire
and shock hazard!
Turning the Power On
Press the [POWER] switch.
The power indicator located above the [MASTER VOL-
UME]
control lights up.
To turn off the power, press the [POWER] switch again.
CAUTION
Never interrupt the power supply while the instrument is load-
ing data from a USB flash memory! Doing so can result in loss
of data.
CAUTION
Even when the instrument is turned off, electricity is still flow-
ing to the instrument at the minimum level. When you are not
using the instrument for a long time or during electrical
storms, make sure you unplug the AC power plug from the
wall AC outlet.
Setting the Volume
Initially set the [MASTER VOLUME] control about halfway
between the “MIN” and “MAX” settings. Then, when you start
playing, re-adjust the [MASTER VOLUME] control to the most
comfortable listening level.
CAUTION
Do not use the instrument at a high volume level for a long period of time, or your hearing may be damaged.
TERMINOLOGY
VOLUME: The volume level of the entire keyboard sound.
TIP
You can also adjust the [PHONES] output level using the [MASTER VOLUME] control.
[AC IN] connector
(The shape of plug dif-
fers depending on your
particular locale.)
Power indicator
[POWER] switch
The level decreases. The level increases.
- Owner’s Manual 1
- SPECIAL MESSAGE SECTION 2
- FCC INFORMATION (U.S.A.) 3
- PRECAUTIONS 4
- About this Owner’s Manual 6
- Accessories 7
- Main Features 8
- Tab le of Contents 9
- Panel Controls and Terminals 10
- H11 Owner’s Manual 11
- Note Name 12
- (BGM) Functions 13
- Before Using the H11 14
- Connecting the Power Cord 15
- Turning the Power On 15
- Setting the Volume 15
- Using Headphones (option) 16
- Using Music Rest (option) 16
- Checking the version number 16
- (Classic & Jazz) 17
- 5 Stop playback 18
- 2 Start playback 19
- 3 Stop playback 19
- 1 Turn on the [USB] lamp 20
- 2 Play any of the USB songs 20
- 4 Turn the [USB] lamp off 21
- Precautions when using 22
- floppy disk to the instrument 23
- Formatting USB storage media 24
- 2 Change the Channel 25
- 3 Start playback 26
- 4 Stop playback 26
- 1 View the voice name 27
- 2 Select a voice 27
- Using the Pedals 28
- 1 Engage Dual mode 29
- 2 Exit from the Dual mode 30
- Transposition – [TRANSPOSE] 31
- Fine Tuning of the Pitch 32
- Touch Sensitivity – [TOUCH] 32
- TERMINOLOGY 33
- [INTERNET] lamp 35
- About the Internet Settings 36
- 1 Engage the Load mode 37
- 2 Start loading 37
- Radio Status Display 38
- 1 Turn on the Export mode 39
- 2 Start exporting 39
- Internet Initial Settings 40
- Glossary of Internet Terms 41
- [LAN] ports 42
- Connections 43
- Data Backup 44
- 1 Engage the Backup mode 45
- 2 Start backup 45
- 3 Exit from the Backup mode 45
- 2 Enable the Restore mode 46
- 4 Exit from the Restore mode 46
- Message List 47
- Troubleshooting 48
- Keyboard Stand Assembly 49
- 3. Attach B 50
- 4. Attach C 50
- 7. Connect the cords 51
- 8. Replace the groove covers 51
- 9. Raise A 52
- 10. Rotate the adjuster 52
- [PRESET 1] (Classic) 53
- [PRESET 2] (Jazz) 54
- Mood Music 54
- IMPORTANT SAFETY INSTRUCTIONS 62
Produits connexes et manuels pour Synthétiseur Yamaha H11
Synthétiseur Yamaha DX7s Manuel du propriétaire
(108 pages)
(108 pages)
Synthétiseur Yamaha YPT-310 Manuel
(90 pages)
(90 pages)
Synthétiseur Yamaha P-250 Manuel
(2 pages)
(2 pages)
Synthétiseur Yamaha XF6 Manuel
(86 pages)
(86 pages)
Synthétiseur Yamaha SH2 Manuel d'utilisateur
(16 pages)
(16 pages)
Synthétiseur Yamaha CLP-280 Manuel
(124 pages)
(124 pages)
Synthétiseur Yamaha SC2 Manuel d'utilisateur
(16 pages)
(16 pages)
© 2020, manymanuals.fr. Tous droits réservés | 2.080 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels