Yamaha RX-A800 Manuel du propriétaire télécharger pdf (Page 19)

CONNECTIONS

Connecting speakers

En 19

Check that “SP IMP.” is displayed on the front panel.

Press STRAIGHT repeatedly to select a “6ΩMIN.”

Switch this unit to the standby mode, and then

switch it on again.

The power turns on, when the settings you made has been

configured.

■

Connecting speakers

This type of jack can connect to the following speakers or

connection.

Remove approximately 0.4 in. (10 mm) of insulation

from the ends of the speaker cables, and twist the

bare wires of the cables together firmly so that they

will not cause short circuits.

Loosen the speaker terminals.

Insert the bare wire of the speaker cable into the gap

on the side of the terminal.

Tighten the terminal.

SPIMP.-8MIN

• Front L/R speakers

• Center speaker

• Surround L/R speakers

• Surround back L/R speakers

• Bi-amp connection (Front speaker L/R speakers)

FRONT

Connecting the banana plug

Tighten the knob, and then insert the banana plug into the end of

the terminal.

FRONT

Banana plug

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 140 141

Pas de commentaire

Yamaha RX-A800 Manuel du propriétaire Page 19