SETUP
Controlling other components with the remote control
En 107
4
Enter a remote control code “2064” using
mNumeric keys. J1
Once the remote control code is registered successfully
pSOURCE/RECEIVER will blink twice.
5
To switch between BD player linked to
scene selections, press iSCENE and at the
same time press dHDMI2 and hold it for
approximately 3 seconds.
Then you can operate the external components by
switching the input source to HDMI2, or selecting
HDMI2 in the registered scene.
Same steps for operating other external components,
press
iSCENE and at the same time press the input
source key selected in step 3 and hold it for
approximately 3 seconds.
Resetting all remote control codes
Resetting all remote control codes for external
components to the initial factory settings.
1
Press oCODE SET using a pointed object
such as the tip of a ballpoint pen.
2
Press pSOURCE/RECEIVER on the remote
control.
3
Enter “9981” using mNumeric keys.
d
HDMI2
iSCENE
mNumeric keys
oCODE SET
pSOURCE/RECEIVER
SCENE
2
BD
DVD
TV
CD
RADIO
7856
90
1234
SOURCE
RECEIVER
CODE SET
OLUME
ENHAN
E
R. DE
DE
TRAI
HT
LEEP
RE DIRE
T
ART
VI
I
ENTER
1
EC
EN
MEN
P-
DI
PLAY
ZONE 2
DI
3
5
-A
D
K
DMI OUT
LT
PTI
N
ON SCREE
5
NF
EMORY
RE
ET
A
SIRIU
TUN.
ATE
R
m
o
p
i
d
• If the registration fails, repeat from step 2.
• In case of an external component with multiple remote
control codes, the other remote control codes may be
supported. Repeat from step 2 with the other remote
control codes.
2 0
6
4
SOURCE
RECEIVER
MAI
NE
ODE SE
HDM
Registration successful: blinks twice
Registration failed: blinks 6 times
Perform each of the following steps within 1 minute.
Settings will be automatically stopped if more than 1
minute passes since the last operation. To reset, repeat
from step 1.
SOURCE
RECEIVER
CODE SET
MAI
NE
HDM
blinks twice
Once the remote control code is reset successfully
pSOURCE/RECEIVER will blink twice.
If setup fails, repeat from step 1.
9 9
8
1
SOURCE
RECEIVER
MAI
NE
ODE SE
HDM
Reset successful: blinks twice
Reset failed: blinks 6 times
J
1 : When you want to register a remote control code to the
nTV control keys, enter the TV remote control code in step 4.
Commentaires sur ces manuels