Yamaha DSP-AX1 Manuel du propriétaire Page 44
- Page / 256
- Table des matières
- DEPANNAGE
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
42
Advanced
Operation
SET MENU Items
Use this feature to adjust the Subwoofer volume so it matches the volume of the other speakers in your configuration. Change the setting
using the remote control while sitting in the main listening position.
1
1
Press + or – (or SET MENU + or –) to set TEST TONE to “ON”, and adjust the volume using VOLUME + (or
VOLUME) so you can hear the tone.
2
2
Press
%
(or NEXT) repeatedly to go to OUTPUT and press + or – (or SET MENU + or –) to select the speaker you
want to compare with the Subwoofer.
• If “SUBWOOFER” is selected, test tones above 90 Hz will not be output from the Subwoofer. The test tone will not necessarily
be output from the selected speakers. The output mode of the test tone depends on the settings of the 1. SPEAKER SET items in
the SET MENU.
3
3
Press
%
(or NEXT) repeatedly to go to FREQ. and press + or – (or SET MENU + or –) to select the frequency you
want to use.
4
4
Adjust the Subwoofer volume using the controls on the Subwoofer so it matches the volume of the speaker you are
comparing it to.
Notes:
• Do not turn up the VOLUME too high.
• If no test tone is heard, turn off the power and make sure all the necessary hookups are correct.
■ About the Test Tone
The test tone is produced by the tone generator.
The tone generator produces a narrow band noise centered at a specified
frequency by the band pass filter.
You can change the center frequency from 35 Hz through 250 Hz in one-sixth
octave steps.
You can use the test tone not only for adjusting the subwoofer level, but also for
checking the low frequency characteristics of your listening room. Low frequency
sounds are especially affected by the listener’s position, speaker placement,
subwoofer polarity and other conditions.
Digital Generator
(Wide Band Noise Produced)
Band Pass Filter
2. LOW FREQ. TEST
Center freq. 35 Hz~250 Hz
NOISE
FREQ.
- OWNER’S MANUAL 1
- MODE D’EMPLOI 1
- BEDIENUNGSANLEITUNG 1
- For U.K. customers 2
- Contents 3
- Introduction 4
- Features 5
- Checking the Package Contents 7
- Front Panel 8
- Remote Control 10
- Controls and Functions 11
- Front Panel Display 12
- Rear Panel 13
- Preparations 14
- Speaker System Configurations 15
- Speaker Placement 16
- Connecting to Digital Jacks 17
- About the Video Jacks 17
- Connecting Audio Components 18
- ■ Connecting a Tape Deck 19
- Connecting Video Components 20
- ■ Connecting a VCR 21
- ■ Connecting a DVD Player 21
- ■ Connecting a Video Monitor 21
- Connecting Speakers 22
- SPLIT jacks using pin plugs 23
- ■ Connecting a Rear Subwoofer 24
- ■ Impedance Selector switch 24
- (SURROUND) 25
- Connecting Power Supply Cords 26
- OSD Modes 27
- Selecting the OSD Mode 27
- Speaker Settings 28
- Before You Begin 29
- DSP Test 31
- Basic Operation 32
- Power Control 33
- Selecting a Source 34
- Input Modes and Indications 35
- Basic Playback 36
- Advanced Operation 38
- SET MENU Items 39
- Operating the SET MENU 40
- 2. LOW FREQ. TEST 44
- 5. SP DELAY TIME 46
- 6. AUDIO DELAY 46
- 4. DTS SET 46
- 9. CINEMA EQ 48
- 13. MEMORY GUARD 50
- 15. INPUT MODE 50
- 16. INPUT RENAME 51
- 17. DIMMER 51
- 18. ZONE 2 SET 51
- Using the Remote Control 52
- Remote Control Features 53
- Each Component Control Area 54
- 5~10 cm (2 to 4 in.) 60
- Using the Macro Feature 61
- Connections 66
- Remote Control in ZONE 2 67
- Additional Information 68
- Understanding Sound Fields 69
- Recreating a Sound Field 69
- E/R (Early Reflection) 69
- Movie Theater Programs 72
- ■ Program Groups 7~9 73
- ■ Program Groups 10~12 73
- Changing Parameter Settings 75
- EFCT TRIM (Effect Trim) 76
- INIT. DLY (Initial Delay) 76
- S. DLY (Surround Delay) 77
- ROOM SIZE 77
- LIVENESS 78
- Appendix 80
- Troubleshooting 81
- Specifications 85
- Table des matières 87
- Particularités 89
- Face avant 92
- Commandes et fonctions 93
- Boîtier de télécommande 94
- Afficheur de la face avant 96
- Panneau arrière 97
- Remarque: 100
- Attention: 101
- R/CRPB/CBY 101
- Remarques: 103
- Raccordements 105
- Raccordement des enceintes 106
- Modes d’affichage sur l’écran 111
- Choix du mode d’affichage 111
- Réglages des enceintes 112
- Avant de commencer 113
- Essai Dolby Surround 114
- Essai DSP 115
- Opérations de base 116
- Commande de l’alimentation 117
- Choix de la source 118
- Modes d’entrée et indications 119
- Lecture standard 120
- Préparatifs 121
- Fonctionnement détaillé 122
- Paramètres de SET MENU 123
- Utilisation de SET MENU 124
- 6. AUDIO DELAY (Retard audio) 130
- 4. DTS SET (Réglage DTS) 130
- 17. DIMMER (luminosité) 135
- Une pression sur la touche % 137
- Une pression sur la touche fi 137
- Fonctionnement 138
- Français 139
- 5 à 10 cm 144
- Ces deux indications 144
- Emploi des macros 145
- ■ Création d’une macro 146
- ■ Enregistrement d’une macro 146
- V-AUX TAPE PHONO 147
- D-TV CBL/SAT TUNER MD CD 147
- VCR 1 VCR 2 VCR 3 LD DVD 147
- ON SCREEN 149
- SLEEP TEST 149
- Informations complémentaires 152
- Qu’est-ce qu’un champ sonore? 153
- Restitution d’un champ sonore 153
- E/R (Premières réflexions) 153
- Hi-Fi DSP-Sound Field Program 154
- CINEMA-DSP 155
- Corrections pour les films 156
- ■ Groupes 7 à 9 de correction 157
- INIT. DLY (Retard initial) 160
- S. DLY (Retard de l’ambiance) 161
- LIVENESS (Vivacité) 162
- Guide de dépannage 79 164
- Guide de dépannage 165
- Caractéristiques techniques 169
- Einleitung 172
- Merkmale 173
- Verwendung der Fernbedienung 175
- Fronttafel 176
- Fernbedienung 178
- Fronttafel-Display 180
- Rückwand 181
- Vorbereitungen 182
- ( ) 183
- Hinweis: 184
- Hinweise: 186
- Anschlüsse 191
- Bevor Sie beginnen 197
- Dolby Surround Test 198
- DSP-Test 199
- Grundlegende 200
- Bedienung 200
- Wahl einer Signalquelle 202
- Eingangsmodi und Anzeigen 203
- Vorsicht: 205
- Weiterführende 206
- PARAMETER 208
- SET MENU 208
- KeinKlein 209
- Groß Klein 209
- ■ Über den Testton 212
- ■ 3A. LFE LEVEL (LFE-Pegel) 213
- 4. DTS SET (DTS-Einstellung) 214
- 9. CINEMA EQ (Kino-Entzerrer) 216
- 12. 6.1/ES AUTO 217
- 17. DIMMER (Abblendung) 219
- Funktionen der Fernbedienung 221
- Zusätzliche Informationen 236
- Verstehen von Sound-Feldern 237
- HiFi DSP-Sound-Feld-Programm 238
- Filmtheater-Programme 240
- Programmtyp (Unterprogramm) 243
- Cursor Parameter 243
- ROOM SIZE (Raumgröße) 245
- Störungsbeseitigung 79 248
- Technische Daten 83 248
- Störungsbeseitigung 249
- Technische Daten 253
- V482940-1Printed in Japan 254
- Quick Reference Card 255
Produits connexes et manuels pour Récepteurs AV Yamaha DSP-AX1
Récepteurs AV Yamaha RX-V3800 Manuel
(459 pages)
(459 pages)
Récepteurs AV Yamaha RX-V765 Manuel
(156 pages)
(156 pages)
Récepteurs AV Yamaha RX-V1900 Manuel
(506 pages)
(506 pages)
Récepteurs AV Yamaha RX-A3010 Manuel
(157 pages)
(157 pages)
(441 pages)
(92 pages)
(18 pages)
Récepteurs AV Yamaha HTR-5650 Manuel
(66 pages)
(66 pages)
© 2020, manymanuals.fr. Tous droits réservés | 3.935 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels