Yamaha CL3 Manuel du propriétaire télécharger pdf (Page 45)

Grouping and linking

Owner’s Manual

Changing the signal output to each

output port

1. Press the SETUP button in the display screen.

2. Press the OUTPORT SETUP button in the

SYSTEM SETUP screen.

3. Select the OUTPUT PORT tab you want to

change.

4. Press the output channel select button to

select the output channel for which you want

to change the port.

Grouping and linking

Creating a channel link

1. Press the CH JOB button in

the display screen.

2. Press the CH LINK button.

3. Select the bank that contains the channels

you want to link in the Channel Strip section

or Centralogic section.

4. While pressing and holding down the [SEL]

key of one channel, press the [SEL] key of the

other channel that you want to link.

5. To release the link, press and hold down the

[SEL] key for one of the linked channels, and

press the [SEL] key for the other channel.

NOTE

You can also set or release a channel link in the display.

Setting a DCA or MUTE group

1. Press the [SEL] key of the channel that you

want to control.

2. Press the DCA tab

or MUTE tab in the

SELECTED

CHANNEL screen.

3. Press the desired

group number

button.

4. To assign other channels to a group, press

DCA or MUTE group numbers in the same

way.

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 64 65

Pas de commentaire

Yamaha CL3 Manuel du propriétaire Page 45