Yamaha CL3 Manuel du propriétaire télécharger pdf (Page 15)

Top panel

Owner’s Manual

Master section

This section is similar to the Channel Strip section, and

enables you to control the principal parameters of the

assigned channels. When the unit is in the default state,

STEREO/MONO channels are assigned.

1 GAIN/PAN/ASSIGN knob

Adjusts the gain or pan of the

channel. You can also assign

parameters to the knob.

On the CL5, switch the

function of the knob using the

[GAIN/PAN/ASSIGN] key

located to the left of the Master

section. On the CL3 and CL1,

switch the function of the knob

using the

[GAIN/PAN/ASSIGN] key

located in the upper right

corner of the Block A in the

Channel Strip section.

2 [SEL] key

Selects the channel you wish to

control. Pressing this key will

cause the channel LED to light

up, and you will be able to

control the channel in both the

SELECTED CHANNEL

section and on the touch

screen.

If the STEREO bus has been

assigned, the selected object of

control will alternate between

the L and R channels each time

you press the [SEL] key.

3 [CUE] key

Selects the channel to be

cue-monitored. If cue is on, the

LED will light.

4 [ON] key

Switches the channel on or off. If a channel is on, the

key LED will light.

If MONITOR has been assigned, this key switches the

monitor output on or off.

5 Channel name display

6 Channel color indicator

Same as that in the Channel Strip section.

7 Fader

Adjusts the output level of the channel.

If MONITOR has been assigned, this fader adjusts the

monitor output level.

USB connector

You can connect a USB flash drive to

the USB connector to record or play

audio files, and to save or load

internal data. The Help file displayed

on the unit screen is loaded from a

connected USB flash drive.

You can also save on a USB flash drive “User authentication

key” data that determines the user level and limit the

functionality to which the user has access.

NOTE

Operation is guaranteed only for a connection with a USB

flash drive.

■ USB flash drive capacities and formats

The operation of USB flash drives with capacities of up to

32 GB has been verified. (However, this does not guarantee

operation of all USB flash drives.)

The FAT16 and FAT32 formats are supported.

■ Prevention of accidental erasure

Some USB flash drives have a write-protect setting that lets

you prevent data from being erased accidentally. If your

flash drive contains important data, it is a good idea to use

the write-protect setting to prevent accidental erasure.

On the other hand, you will need to make sure that your

USB flash drive’s write-protect setting is turned off before

you save data onto it.

NOTICE

An ACCESS indicator appears in the Function Access

Area while data is being accessed (saved, loaded, or

deleted). During this time, do not disconnect the USB flash

drive or power-off the CL unit. Doing so may damage your

flash drive, or may damage the data in the CL unit or on

your media device.

Meter section (for CL5 only)

Indicates the level of MIX/MATRIX, STEREO/MONO and

CUE channels. You can select the monitoring position from

PRE EQ (immediately before EQ), PRE FADER

(immediately before the fader), or POST ON (immediately

after the [ON] key).

You can use this function on the CL3 or CL1 if you install

an optional MBCL meter bridge.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 64 65

Commentaires sur ces manuels

Pas de commentaire

Yamaha CL3 Manuel du propriétaire Page 15

Commentaires sur ces manuels

Produits connexes et manuels pour Mélangeurs audio Yamaha CL3