Yamaha CL3 Manuel du propriétaire télécharger pdf (Page 39)

Quick Guide

Owner’s Manual

Quick Guide

This section explains the general procedures in a mixing

workflow. The example below is based on a system in

which one CL5, one I/O device, an amplifier and speakers

are connected. If there are multiple methods to achieve the

same result, this section introduces the simplest method.

For details on the functions and their parameters, refer to

the Reference Manual.

Connecting the devices

Setting up the Dante network

1. Press the SETUP button in the touchscreen.

2. Press the DANTE SETUP button in the SETUP

screen.

3. In the lower part of the DANTE SETUP screen,

press the SETUP tab.

4. Set CONSOLE ID to #1, and SECONDARY

PORT to DAISY CHAIN.

NOTE

If you want to change the settings, you must first

disconnect all I/O devices before doing so. If you fail to do

so, communication with the I/O devices will become

impossible.

If you changed the settings, press the APPLY button;

when the confirmation screen appears, click the OK

button.

The button you changed will change from red back to

white; please wait approximately 30 seconds for the

settings to be applied.

5. Set BIT to 24, and LATENCY to 0.25.

Connecting I/O devices

1. Make sure that power to all devices to be

connected is turned off. Then, use an

Ethernet cable to connect the Dante

PRIMARY connector on the CL to the Dante

PRIMARY connector on the I/O device.

2. Specify the ID of the I/O device.

NOTE

If you plan to use one I/O device, set its ID number to “1.”

If you plan to use multiple devices, you must assign a

unique ID number to each device.

3. Turn on the power to the I/O device, the CL

series, and then the amplifier, in that order.

4. In the touchscreen, press the SETUP button,

then the DANTE SETUP button, and finally the

DEVICE MOUNT tab.

5. Check the I/O devices.

NOTE

If you’re connecting an I/O device other than the

Rio3224-D, you’ll need to mount it.

See the reference manual for details.

6. Connect mics or instruments to the I/O

device.

Setting the word clock

1. Press the SETUP button

in the display screen,

then press the WORD

CLOCK/SLOT SETUP

button.

2. Select INT 48k or INT

44.1k.

3. Press the X symbol to close the screen.

➩

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 64 65

Commentaires sur ces manuels

Pas de commentaire

Yamaha CL3 Manuel du propriétaire Page 39

Commentaires sur ces manuels

Produits connexes et manuels pour Mélangeurs audio Yamaha CL3