Yamaha PSR8000 Manuel du propriétaire télécharger pdf (Page 59)

E3:FILTER

■ FILTER1 & FILTER2...................................................................................................................................................................

These parameters allow you to specify two separate touch-

sensitive (dynamic) filter types. The available types are LPF

(Low Pass Filters — LPF1 and LPF2 for FILTER1), BPF

(Band Pass Filter), HPF (High Pass Filter), and BEF (Band

Elimination Filter). The FREQ. parameters set the initial fre-

quency of the corresponding filters.

■ RESONANCE ...................................................................................................................................................................................

Sets the amount of peak resonance applied to FILTER 1.

Higher values produce more resonant emphasis.

■ TOUCH TO FILTER..................................................................

The TYPE parameters specifies the touch-sensitivity curve to

be applied to the dynamic filters, and the SENS parameters sets

the sensitivity of the filters to touch control. Higher values

produce higher sensitivity.

E4:LFO

■ LFO (Low Frequency Oscillator)..................................................................................................................................................

The LFO parameters set the LFO (Low Frequency Oscillator) to

produce cyclic pitch, timbre, and amplitude modulation.

PMOD Sets the pitch modulation depth. Higher values

produce deeper modulation.

FMOD Sets the frequency modulation depth. Higher

values produce deeper modulation.

AMOD Sets the amplitude modulation depth. Higher

values produce deeper modulation.

SPEED Sets the speed of LFO variation.

TYPE Sets the waveform of the LFO: TRI (triangular) or

SAW (sawtooth).

• The RESET LCD button resets the currently selected FILTER parameters so that no filter effect is applied.