Yamaha PSR8000 Manuel du propriétaire télécharger pdf (Page 44)

TUNING

■ TRANSPOSE ................................................................................

The MASTER TRANSPOSE parameter duplicates the function

of the MASTER TRANSPOSE [<] and [>] buttons on the

PSR-8000 panel. Use the MASTER TRANSPOSE dial to set

overall PSR-8000 transposition in semitone increments over a

±24 semitone range. “0” is standard pitch. Adjusting the MAS-

TER TRANSPOSE parameter automatically adjusts the SONG

TRANSPOSE parameter by the same amount.

Use the SONG TRANSPOSE dial to set SONG playback

transposition in semitone increments over a ±24 semitone

range. “0” is standard pitch.

■ TUNING ..................................................................................................................................................................................................

These parameters fine-tune the corresponding parts from “–64” (down a semitone) to “+63” (up a semitone). “0” is

standard pitch.

■ OCTAVE .................................................................................................................................................................................................

These OCTAVE parameters are separate from the octave parameters accessed via the normal play mode display (page

27), and have a –2 … +2 range as opposed to the –1 … +1 range of the play-mode octave parameters. The values

of the mixer’s OCTAVE parameters are

added to those of the corresponding play-mode octave parameters.

■ PITCH BEND RANGE ..............................................................................................................................................................

Set the range of the PITCH BEND wheel for the corresponding part. The range is from “0” to “12” with each step

corresponding to one semitone.

■ PORTAMENTO TIME .................................................................................................................................................................

Set the portamento time for the corresponding parts only when the parts are set to “MONO” (page 22). The higher

the value the longer the portamento time. The portamento effect (a smooth slide between notes) is produced when

the notes are played legato: i.e. a note is held while the next note is played.

The Mixing Console