Yamaha PSR8000 Manuel du propriétaire télécharger pdf (Page 152)

152

Optional SIMM Installation

ZBefore installing the SIMMs be sure to save any impor-

tant data to disk by using the SAVE TO DISK function

described on page 141. Also remove the backup batteries.

Turn the PSR-8000 power OFF and unplug the power

cord from both the AC wall socket and the instrument’s

rear panel. Turn the instrument upside down and rest it on

a blanket or other soft surface.

Installing Options

The SIMMs used must meet the following minimum specifi-

cations, but this does not guarantee that they will work

properly with the PSR-8000. Consult with your nearest

Yamaha representative or an authorized distributor listed at

the end of this manual before purchasing SIMMs for the

PSR-8000.

• 16-bit bus compatibility or compliance with JEDEC standards

(SIMMs which are only compatible with 32-bit buses can not be

used)

• 70 nanoseconds or faster access time (note: 60 nanosecond

SIMMs are “faster” than 70 nanosecond SIMMs).

• No more than 18 memory chips on each SIMM module.

• SIMM modules must be no more than 40 mm in height and the

thickness of the SIMM should not exceed 8mm on either side

when measured from the center of the SIMM. See below.

• SIMMs with parity and EDO DRAM modules can also be used.

• Use only 4, 8, or 16 megabyte memory modules in pairs of the

same type and memory capacity from the same manufacturer:

e.g. 4, 8, or 16 megabytes x 2.

• Install SIMM memory at your own risk. Yamaha will not be held

responsible for any damage or injury resulting from improper

installation.

40mm

8mm

1 2 ... 147 148 149 150 151 152 153 154 155 156 157 ... 205 206

Pas de commentaire

Yamaha PSR8000 Manuel du propriétaire Page 152