Yamaha RX-V1800 Manuel du propriétaire Page 35

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 151
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 34
33 En
Connections
PREPARATION
English
1 Make sure this unit is turned off.
2 Press and hold
O
STRAIGHT on the front
panel and then press
A
MASTER ON/OFF
inward to the ON position to turn on this unit.
This unit turns on, and the advanced setup menu
appears in the front panel display.
3 Rotate the
N
PROGRAM selector to select
“SPEAKER IMP.”.
4 Press
O
STRAIGHT repeatedly to select
“6 MIN”.
5 Press
A
MASTER ON/OFF to release it
outward to the OFF position to save the new
setting and turn off this unit.
The setting you made is reflected next time you turn on this unit.
Turning on this unit
Press
A
MASTER ON/OFF on the front panel
inward to the ON position to turn on this unit.
When you turn on this unit by pressing
A
MASTER ON/
OFF, the main zone is turned on.
y
When you turn on this unit, there will be a delay for a few
seconds before this unit can reproduce sound.
Turning off this unit
Press
A
MASTER ON/OFF on the front panel
again to release it outward to the OFF position to
turn off this unit.
B
MAIN ZONE ON/OFF on the front panel as well as
8
POWER and
7
STANDBY on the remote control are
operational only when
A
MASTER ON/OFF is pressed
inward to the ON position.
Basically, we recommend that you use the standby mode to turn
off this unit.
Set the main zone to the standby mode
Press
B
MAIN ZONE ON/OFF
(or
7
STANDBY
)
to set the main zone to the standby mode.
In the standby mode, this unit consumes a small amount of
power in order to receive infrared signals from the remote
control.
Turning on the main zone from the
standby mode
Press
B
MAIN ZONE ON/OFF (or
8
POWER) to
turn on the main zone.
y
When you turn on this unit, there will be a delay for a few
seconds before this unit can reproduce sound.
These buttons are operational only when
A
MASTER ON/
OFF is pressed inward to the ON position.
Setting the speaker impedance
Caution
If you are to use 6-ohm speakers, set “SPEAKER
IMP.” to “6 MIN” as follows BEFORE using this
unit. You can also use 4-ohm speakers as the front
speakers.
Note
EFFECT
STRAIGHT
MASTER
While holding
down
Turning this unit on and off
Notes
If there are some problems...
First, turn off and then turn on this unit again.
If problems persist, initialize the parameters of this
unit. See page 124 for details.
Vue de la page 34
1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 150 151

Commentaires sur ces manuels

Pas de commentaire