Yamaha wr450f Manuel d'utilisateur télécharger pdf (Page 13)

Fasten the fork leg, at the fork bottom, in a vice

with soft jaws.

Install the compression valve assembly in the

fork bottom.

Tightening torque 60 Nm.

Apply some front fork oil on the outer surface of

the inner leg, and push the outer leg up and down

a few times.

First, fill up the cartridge tube, then raise up the

outer leg about 250 mm and add the remaining

oil.

Install the fork top cap and the lock nut.

Tighten the top cap and the lock nut against each

other, use tool 1860-01, a 17 mm and 24 mm

wrench. Tighten to 20 Nm.

Fit the fork legs on the motorcycle. Tighten the

upper triple clamp to 20 Nm and the lower triple

clamp to 10 Nm.

Adjust the compression and the rebound valves

according to the specification card.

Install the damper rod assembly into the cylinder

tube.

Use Loctite 542 on the cylinder tube cap.

Tighten with tool 1797-01.

Tightening torque 60 Nm.

Pump the damper rod up and down a few times

to check that there is no air left.

Measure the correct amount of oil according to

the specification card.

Pull out the damper rod as far as possible and

close the compression and the rebound valves.

Install the spring and the spring support.

Compression

valve assy

60 Nm

Damper rod assy

Cylinder

tube

Cylinder

tube cap

Top cap

24 mm

wrench

Damper

rod assy

Damper rod

extender

17 mm

wrench

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 19 20

Commentaires sur ces manuels

Pas de commentaire

Yamaha wr450f Manuel d'utilisateur Page 13

Commentaires sur ces manuels

Produits connexes et manuels pour Motocyclettes Yamaha wr450f