Yamaha wr450f Manuel d'utilisateur télécharger pdf (Page 11)

Remove the seal and bushing and check them

for wear and damage. Replace if necessary.

CAUTION!

When removing the oil seal and bushing use a

small plastic bag to cover the bushing attachment

groove and edges of the inner tube, to avoid

damage to the seals.

Fasten the damper rod assembly in a vice with

soft jaws. Use tool 0727-02.

CAUTION !

Fasten the damper rod assembly in a vice.

Be carful not to tighten too hard. The piston rod

is very delicate.

Remove all parts from the piston holder.

NOTE!

If the correct order is lost, use the specification

card as a guide.

Put them in the correct order on the bench. Clean

all parts thoroughly.

Inspect all parts for wear and damage, replace

if necessary.

Assemble the damper rod.

Remove the compression valve assembly from

the fork bottom using a 17 mm socket.

Fasten the valve assembly with soft jaws in a

vice.

Remove all parts from the valve body and put

them in the right order on the bench. Clean all

parts thoroughly.

Inspect all parts for wear and damage, replace

if necessary.

Assemble the compression valve.

Bushing

Sleeve

Seal

Rebound

valve assembly

Compression

valve assembly

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 19 20

Pas de commentaire

Yamaha wr450f Manuel d'utilisateur Page 11