Yamaha wr450f Manuel d'utilisateur télécharger pdf (Page 10)

Perform steps 1-2 on page 7.

Loosen the cylinder tube cap, on top of the cylinder

tube, with tool 1797-03.

Lift up the damper rod assembly and drain the

oil.

Pull up the scraper with a screwdriver, release

and remove the circlip.

CAUTION!

The fork legs have one fixed bushing and one

sliding bushing. Be very careful when disassem-

bling the fork legs.

Fasten the fork leg horizontally in a vice with soft

jaws.

Use a hot air gun to warm up the outer leg where

the bushings are located.

The fixed bushing is located at the bottom end of

the outer leg.

A sleeve is fitted above the bushing to main-

tain the correct position.

Use the special tool (1702-04) to remove the

bushing.

Install the tool in the top of the inner steel leg.

Install the tool in the outer leg.

Rotate the tool to press out the bushings.

If tool (1702-04) is not avaliable, push the inner

steel leg to the bottom and then pull it back

quickly, so that the fork is topping out hard.

Repeat this procedure until the seal and the

bushing can be pulled out from the outer leg.

CAUTION!

This must be carried out with great care to avoid

damages on surface and bushing.

Tool 1797-03

Cylinder tube

Damper

rod assy

Inner leg

Outer tube

Fixed bushing

Outer

tube

Sleeve

Seal

Bushing

Tool

1702-04

Inner leg

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 19 20

Commentaires sur ces manuels

Pas de commentaire

Yamaha wr450f Manuel d'utilisateur Page 10

Commentaires sur ces manuels

Produits connexes et manuels pour Motocyclettes Yamaha wr450f