Yamaha RX-V465 Manuel du propriétaire Page 52
- Page / 136
- Table des matières
- DEPANNAGE
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
50 En
Troubleshooting
The audio input
sources cannot be
played in the desired
digital audio signal
format.
The connected component is not set to
output the desired digital audio signals.
Set the playback component properly referring to its
operating instructions.
—
Noise/hum noise is
heard.
Incorrect cable connection. Connect the audio cables properly. If the problem
persists, the cables may be defective.
—
A DTS-CD is being played back. 1) When only noise is output
If a DTS bitstream signal is not properly input to this
unit, only noise is output. Connect the playback
component to this unit by digital connection and play
back the DTS-CD. If the condition is not improved,
the problem may results from the playback
component. Consult the manufacturer of the playback
component.
2) When noise is output during playback or skip
operation
Before playing back the DTS-CD, display the option
menu after selecting the input source and set
“Decoder Mode” to “DTS.”
16, 36
“Memory Guard!” is
displayed and the
setting cannot be
changed.
“Memory Guard” in “Setup Menu” is set
to “On.”
Set “Memory Guard” to “Off.” 45
This unit does not
operate properly.
The internal microcomputer is frozen due
to an external electric shock (such as
lightning or excessive static electricity) or
by a drop in power supply voltage.
Disconnect the power cable from the AC wall outlet,
wait about 30 seconds and then plug it in again.
—
“CHECK SP WIRES!”
appears on the front
panel display.
Speaker cables are short-circuited. Make sure all speaker cables are connected correctly. 12
There is noise
interference from
digital or radio
frequency equipment.
This unit is too close to other digital or
radio frequency equipment.
Move this unit further away from such equipment. —
The picture is
disturbed.
The video software is copy-protected.
This unit suddenly
enters the standby
mode.
The internal temperature becomes too
high and the overheat protection circuitry
has been activated.
Wait about 1 hour for this unit to cool down and then
turn it back on.
—
HDMI™
Problem Cause Remedy
See
page
No picture or sound. The number of the connected HDMI
components is over the limit.
Disconnect some of the HDMI components. —
The connected HDMI component does not
support high-bandwidth digital copyright
protection (HDCP).
Connect an HDMI component that supports HDCP. 15
Problem Cause Remedy
See
page
- AV Receiver 1
- Caution-i En 2
- Contents 3
- INTRODUCTION 4
- About this manual 5
- Supplied accessories 5
- Part names and functions 6
- Rear panel 7
- Front panel display 8
- Quick start guide 10
- PREPARATION 11
- Remote control sensor window 11
- 30 cm (12 in) or more 12
- Connecting speakers 13
- Connecting the speaker cable 14
- R) components 15
- TV, or projector 16
- Digital output 16
- (optical) 16
- Connecting other components 17
- Connections 18
- Connecting the power cable 19
- Turning this unit on and off 19
- Using Auto Setup 20
- EQ;;;;;Natural 21
- YPAOComplete 21
- >SetCancel 21
- W-1:PHASE 22
- BASIC OPERATION 23
- Input source name 23
- Sleep 120min. Sleep 90min 24
- Input source 25
- Program name 26
- Sound field program category 26
- For audio music sources 27
- For stereo reproduction 27
- The Compressed Music Enhancer 28
- Surround decode mode 28
- FM92.50MHz 30
- Auto Preset 30
- 01:FM92.50MHz 31
- Frequency display 32
- Current frequency 33
- Using iPod™ 34
- 2 Press mOPTION 35
- Using Bluetooth™ components 36
- ADVANCED OPERATION 37
- Sound field program 40
- EFCT LVL 41
- Panorama 41
- Dimension 41
- CT Width 41
- Setting remote control codes 48
- APPENDIX 50
- Troubleshooting 51
- Tuner (FM/AM) 53
- Remote control 54
- After Auto Setup 56
- Glossary 57
- Information on HDMI™ 59
- Additional information 60
- Specifications 61
- Предупреждение-i Ru 64
- Содержание 65
- ВВЕДЕНИЕ 66
- О данном руководстве 67
- Поставляемые принадлежности 67
- Передняя панель 68
- Задняя панель 69
- Дисплей передней панели 70
- CODE SET 71
- TRANSMIT 71
- ПОДГОТОВКА 73
- Окно сенсора ДУ 73
- 30 см или более 74
- Подключение колонок 75
- Подключение кабеля колонки 76
- B) и насыщенности 77
- Телевизор или проектор 78
- Цифровой выход 78
- (оптический) 78
- Подключения 80
- Подключение FM- и AM-антенн 81
- Подключение силового 81
- Включение и выключение 81
- Использование Auto Setup 82
- ОСНОВНЫЕ ОПЕРАЦИИ 85
- Громкость 85
- Источник входных сигналов 87
- Название программы 88
- Compressed Music Enhancer 90
- 2 Для отмены режима прямого 91
- Номер предустановки Частота 92
- Повторяемость индикации 94
- Текущая частота 95
- Использование iPod™ 96
- 2 Нажмите кнопку mOPTION 97
- ДОПОЛНИТЕЛЬНЫЕ ОПЕРАЦИИ 99
- Decoder Mode 100
- EXTD Surround 100
- Signal Info 100
- Программа звукового поля 102
- Параметры декодера 103
- Dimmer;;;;;;;0 105
- Sound Setup 107
- Function Setup 108
- DSP Parameter 109
- Memory Guard 109
- Установка кодов ДУ 110
- Переустановка всех кодов ДУ 110
- ADVANCEDSETUP 111
- ПРИЛОЖЕНИЕ 112
- Тюнер (FM/AM) 115
- Пульт ДУ 115
- Примечание 116
- Bluetooth™ 117
- Auto Setup (YPAO) 117
- После Auto Setup 118
- Глоссарий 119
- Информация о HDMI™ 121
- Дополнительная информация 122
- Технические характеристики 123
- List of remote control codes 126
- Blu-ray Disc 132
- DVD Recorder 132
- Sattelite 133
- Printed in China WQ95720 136
Produits connexes et manuels pour Récepteurs AV Yamaha RX-V465
Récepteurs AV Yamaha MCR-550 Manuel
(56 pages)
(56 pages)
(18 pages)
Récepteurs AV Yamaha RX-V365 Manuel
(196 pages)
(196 pages)
Récepteurs AV Yamaha RX-V765 Manuel
(324 pages)
(324 pages)
Récepteurs AV Yamaha HTR-6230 Manuel
(104 pages)
(104 pages)
Récepteurs AV Yamaha RX-V463 Manuel
(273 pages)
(273 pages)
© 2020, manymanuals.fr. Tous droits réservés | 0.320 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels