Yamaha RX-V3800 Manuel Page 36
- Page / 169
- Table des matières
- DEPANNAGE
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
32 En
Connections
Both FM and AM indoor antennas are supplied with this
unit. Connect each antenna correctly to the designated
terminals. In general, these antennas should provide
sufficient signal strength.
• (Asia and General models only) Be sure to set the tuner
frequency step according to the frequency spacing in your area
(see page 126).
• The AM loop antenna should be placed away from this unit.
• The AM loop antenna should always be connected, even if an
outdoor AM antenna is connected to this unit.
• A properly installed outdoor antenna provides clearer reception
than an indoor one. If you experience poor reception quality,
install an outdoor antenna. Consult the nearest authorized
Yamaha dealer or service center about outdoor antennas.
■ Connecting the AC power cable
Plug the supplied AC power cable into the AC inlet after
all other connections are complete, then plug the AC
power cable into an AC wall outlet.
(Asia model only) Select one of the supplied power cables
suitable for the type of AC wall outlet in your location before
plugging this unit into the AC wall outlet.
■ AC OUTLET(S) (SWITCHED)
U.K. and Australia models..................................... 1 outlet
Korea model............................................................... None
Other models......................................................... 2 outlets
Use these outlet(s) to supply power to any connected
components. Connect the power cable of your other
components to these outlet(s). Power to these outlet(s) is
supplied when this unit is turned on. However, power to
these outlet(s) is cut off when this unit is turned off. For
information on the maximum power or the total power
consumption of the components that can be connected to
these outlet(s), see “Specifications” on page 144.
Connecting the FM and AM
antennas
Notes
ANTENNA
FM
GND
AM
Indoor FM
antenna
(supplied)
Ground (GND terminal)
For maximum safety and minimum interference, connect the
antenna GND terminal to a good earth ground. A good earth
ground is a metal stake driven into moist earth.
AM loop
antenna
(supplied)
Outdoor AM antenna
Use a 5 to 10 m (16 to 32 ft)
vinyl-covered wire extended
outdoors from a window.
Connecting the power cable
Note
Memory back-up
The memory back-up circuit prevents the stored data
from being lost even if this unit is in the standby mode.
However, the stored data will be lost in case the power
cable is disconnected from the AC wall outlet or if the
power supply is cut off for more than one week.
AC IN
AC OUTLETS
To the AC wall outlet
- RX-V3800 1
- Important safety instructions 2
- Caution-ii En 3
- Caution-iii En 4
- Contents 5
- About this manual 6
- Features 7
- Supplied accessories 8
- Getting started 9
- Quick start guide 10
- Indoor FM antenna 13
- AM loop antenna 13
- Open the lever 13
- Close the lever 13
- ■ After using this unit 14
- Connections 16
- Placing speakers 17
- ■ 6.1-channel speaker layout 18
- ■ 5.1-channel speaker layout 18
- Connecting speakers 19
- SPEAKERS 20
- Using presence speakers 21
- ■ Connecting the banana plug 23
- B, PR) video signals 24
- Information on HDMI™ 25
- Audio and video signal flow 26
- MONITOR OUT 27
- BD/HD DVD 28
- ■ Connecting a DVD player 29
- ■ Connecting a set-top box 30
- ■ Connecting audio components 31
- MULTI CH INPUT 33
- ■ Using REMOTE IN/OUT jacks 34
- Connecting the network 35
- Connecting the FM and AM 36
- Connecting the power cable 36
- Turning this unit on and off 37
- Using the remote control 38
- Front panel display 39
- DIGITAL PLUS 40
- Using the automatic setup 41
- (Auto Setup) 41
- Exit Detail 42
- Measurement Over 42
- Successfully 42
- Warning messages 43
- Playback 45
- Selecting audio input jacks 46
- (AUDIO SELECT) 46
- Selecting the MULTI CH INPUT 46
- Using your headphones 46
- Muting the audio output 47
- Playing video sources in the 47
- Using the sleep timer 47
- ■ Items in GUI screen 48
- Sound field programs 49
- ■ For audio music sources 50
- ■ For various sources 51
- ■ For visual sources of music 52
- ■ For movie sources 52
- ■ Stereo playback 53
- Using CINEMA DSP 3D mode 54
- Enjoying unprocessed input 54
- Using audio features 55
- Adjusting the speaker level 56
- 2-channel stereo 56
- FM/AM tuning 57
- Automatic preset tuning 58
- Manual preset tuning 58
- Selecting preset stations 59
- Exchanging preset stations 59
- XM™ Satellite Radio tuning 60
- 1 Rotate the 61
- ■ All Channel Search mode 62
- ■ Category Search mode 62
- ■ Preset Search mode 62
- ■ Direct Number Access mode 62
- Displaying the XM™ Satellite 64
- Radio information 64
- Using iPod™ 66
- Using Network/USB features 68
- ■ Remote control operation 69
- Using a PC server or Yamaha 70
- MCX-2000 70
- Using the Internet Radio 71
- USB portable audio player 72
- Using shortcut buttons 72
- (1-8) (6) 73
- Recording 74
- Advanced sound configurations 75
- SUR.DECODE 76
- Stereo/Surround 78
- (Stereo/Surround menu) 78
- “Yes” (see page 92) 79
- Rev. Delay 82
- Rev. Level 82
- The Compressed Music 83
- Enhancer mode 83
- Decoder parameter Features 84
- Input Select 85
- ■ I/O Assignment 86
- (Input/output assignment) 86
- ■ Decoder Mode (Decoder mode) 86
- Manual Setup (Volume) 88
- Manual Setup (Sound) 89
- ■ Tone Control (Tone control) 90
- ■ Lipsync 91
- ■ Channel Mute (Channel mute) 92
- Manual Setup (Video) 93
- Short Message 94
- On Screen 94
- Position 94
- Wall Paper 94
- Manual Setup (Basic) 95
- Manual Setup (NET/USB) 98
- Manual Setup (Option) 100
- ■ Zone2 Set/Zone3 Set 101
- (Zone 2/Zone 3 setting) 101
- Signal Info 102
- (Input signal information) 102
- Language 103
- 1 Press 104
- SYSTEM MEMORY 105
- Using examples 106
- CLASSICAL LIVE/CLUB 108
- ENTERTAIN 108
- Remote control features 109
- Set to SOURCE 110
- Setting remote control codes 111
- Programming codes from other 113
- Changing source names in the 114
- Macro programming features 115
- ■ Default macro functions 116
- 4 Press 117
- Clearing configurations 118
- 2 Press 119
- 3 Press and hold 119
- 2 Press and hold 120
- 3 Press 120
- ■ Using external amplifiers 121
- Controlling Zone 2 or Zone 3 122
- Advanced setup 126
- ■ Wake on RS-232C access 127
- ■ Remote control AMP ID 127
- ■ Remote control TUNER ID 128
- Troubleshooting 131
- ADDITIONAL 133
- INFORMATION 133
- ■ Remote control 135
- ■ Network and USB 136
- ■ Auto Setup 139
- During Auto Setup 140
- After Auto Setup 140
- Resetting the system 141
- Glossary 142
- ■ Frequency 147
- ■ Q factor 147
- Specifications 148
- ■ HDMI signal compatibility 149
- ■ Numerics 150
- DEFG H IJ MKL 154
- GPL/LGPL 158
- APPENDIX 159
- MODIFICATION 160
- List of remote control codes 162
- SATELLITE TUNER 163
- TAPE DECK 163
- Printed in Malaysia 169
Produits connexes et manuels pour Récepteurs AV Yamaha RX-V3800
Récepteurs AV Yamaha RX-Z1 Manuel
(95 pages)
(95 pages)
Récepteurs AV Yamaha RX-V565 Manuel
(76 pages)
(76 pages)
(323 pages)
Récepteurs AV Yamaha RX-V1 Manuel
(95 pages)
(95 pages)
Récepteurs AV Yamaha RX-V740 Manuel
(71 pages)
(71 pages)
© 2020, manymanuals.fr. Tous droits réservés | 0.873 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels