Yamaha EF2000iS - Inverter Generator Manuel du propriétaire télécharger pdf (Page 15)

– 10 –

AE01087

Overload indicator light (Red)

The overload indicator light 1 comes on when an over-

load of a connected electrical device is detected, the

inverter control unit overheats, or the AC output voltage

rises. Then, the AC protector will trip, stopping power

generation in order to protect the generator and any

connected electric devices. The AC pilot light (Green)

will go off and the overload indicator light (Red) will stay

on, but the engine will not stop running.

When the overload indicator light comes on and power

generation stops, proceed as follows:

1. Turn off any connected electric devices and stop

the engine.

2. Reduce the total wattage of connected electric

devices within the rated output.

3. Check for blockages in the cooling air inlet and

around the control unit. If any blockages are found,

remove them.

4. After checking, restart the engine.

TIP

The overload indicator light may come on for a few sec-

onds at first when using electric devices that require a

large starting current, such as a compressor or a sub-

mersible pump. However, this is not a malfunction.

7DK-021

7DK-022

Fuel tank cap

Remove the fuel tank cap by turning it counterclock-

wise.

7DK-9-11_a 11.3.21 15:19 Page 10

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 61 62

Pas de commentaire

Yamaha EF2000iS - Inverter Generator Manuel du propriétaire Page 15