Yamaha MCR-640 Manuel télécharger pdf (Page 14)

PREPARATIONS

12 En

Before starting playback operation, follow the procedure

below to adjust the clock setting of the receiver.

Notes

• Use the remote control to set the clock. You cannot set the clock

with the buttons on the receiver.

• The receiver supports 24-hour clock display.

• If you do not touch any key for 90 seconds, the receiver returns

to normal mode.

1 Press to turn the receiver on.

The front panel display lights up.

2 Press TIMER to show the current time.

If the clock is not set, “SET TIME” flashes on the

display.

Press ENTER to proceed to step 3.

3 Press / to select “TIME”, and press

ENTER.

The receiver enters clock setting mode. The hour

digits start flashing.

4 Set the hour using / , and press .

The minute digits start flashing.

5 Set the minutes using / , and press

ENTER.

The hour and minute digits start flashing.

To change the hour or minutes again, press or ,

do steps 4 and 5, and proceed to step 6.

6 Press ENTER.

The clock is set.

The hour and minute segments stop flashing and

remain on. The receiver returns to the normal mode.

You can return to the previous screen by pressing .

Adjusting the Clock

TIMER

ENTER

Flashes

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 91 92

Pas de commentaire

Yamaha MCR-640 Manuel Page 14