Yamaha RX-V665 Manuel du propriétaire télécharger pdf (Page 52)

50 En

This unit allows you to configure a multi-zone audio system. The Zone2 feature allows you to set this unit to reproduce

separate input sources in the main zone and the second zone (Zone2). You can control this unit from the second zone

using the supplied remote control.

You need the following additional equipment to use the

multi-zone functions of this unit:

• An infrared signal receiver in the second zone.

• An infrared signal emitter in the main zone. This emitter

transmits infrared signals from the remote control to a

CD player or a DVD player, etc. in the main zone via

the infrared signal receiver in the second zone.

• An amplifier and speakers in the second zone.

• Since there are many possible ways to connect and use this unit in a

multi-zone configuration, we recommend that you consult with your

nearest authorized Yamaha dealer or service center about the Zone2

connections that best meet your requirements.

• Some Yamaha models can be directly connected to the REMOTE jacks

of this unit. You may not need use an infrared signal emitter for these

products. Up to 6 Yamaha components can be connected as shown below.

Connect the amplifier/receiver in the second zone and

other components to this unit as follows.

Note

• To avoid unexpected noise, DO NOT USE the Zone2 feature with CDs

encoded in DTS.

Connect the speakers in the second zone to the EXTRA

SP terminals and then set the “Extra SP Assign” to

“Zone2” (see page 44).

• You can use the speakers connected to EXTRA SP speaker terminals as

the front speaker system of another zone. Set “Extra SP Assign” to

“Zone2” (see page 44).

• When you use the internal amplifiers for the Zone2 speakers, you can

adjust the volume level and set the initial volume and maximum volume

of the Zone2 speakers (see page 49).

Using multi-zone configuration

Only analog signal can be sent to Zone2. If you want to output the sound from Zone2, connect an external component

to AV5-6 or AUDIO1-2 by analog connection. For example, if you want to output sound from an HDMI DVD player

in Zone2, you must connect the component to this unit by both HDMI and analog connections.

Connecting Zone2

Using the external amplifier

OUT

REMOTE

OUT

REMOTE

This unit Yamaha

component

Infrared signal

receiver

To the REMOTE IN jack

Infrared signal

emitter

DVD player (etc.)

Amplifier

Remote control

Second zone

(Zone2)

Main zone

This unit

From the ZONE2 OUT jacks

Infrared signal

receiver

From the REMOTE OUT jack

Using the internal amplifier of this unit

Important safety notice

The EXTRA SP speaker terminals of this unit should

not be connected to a Passive Loudspeaker Selector

Box or more than one loudspeaker per channel.

Connection to a Passive Loudspeaker Selector Box or

multiple speakers per channel could create an

abnormally low impedance load resulting in amplifier

damage. See this owner’s manual for correct usage.

Compliance with minimum speaker impedance

information for all channels must be maintained at all

times. This information is found on the back panel of

your unit.

EXTRA SP

ZONE2/PRESENCE

Second zone

(Zone2)

This unit

Main zone

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 155 156

Commentaires sur ces manuels

Pas de commentaire

Yamaha RX-V665 Manuel du propriétaire Page 52

Commentaires sur ces manuels

Produits connexes et manuels pour Récepteurs AV Yamaha RX-V665