Yamaha RX-V665 Manuel du propriétaire télécharger pdf (Page 21)

19 En

English

INTRODUCTION

ADDITIONAL

INFORMATION APPENDIX

PREPARATION

BASIC

OPERATION

ADVANCED

OPERATION

This unit has a Yamaha Parametric Acoustic Optimizer (YPAO). With the YPAO, this unit automatically adjusts the

output characteristics of your speakers based on speaker position, speaker performance, and the acoustic characteristics

of the room. We recommend that you first adjust the output characteristics with the YPAO when you use this unit.

1 Check the following points.

Before starting the automatic setup, check the

following.

• All speakers and subwoofer are connected

properly.

• Headphones are disconnected from this unit.

• The video monitor is connected properly.

• This unit and the video monitor are turned on.

• This unit is selected as the video input source of the

video monitor.

• The connected subwoofer is turned on and the

volume level is set to about half way (or slightly

less).

• The crossover frequency controls of the connected

subwoofer are set to the maximum.

2 Connect the supplied optimizer microphone

to the OPTIMIZER MIC jack on the front

panel.

“MIC ON. View OSD MENU” appears on the front panel

display.

The following menu screen appears on the video monitor.

• You can bring up the above menu screen from the setup menu (see

page 44).

3 Place the optimizer microphone at your

normal listening position on a flat level

surface with the omni-directional

microphone heading upward.

• It is recommended that you use a tripod or something similar to fix the

optimizer microphone at the same height as your ears would be when

seated in your listening position. You can fix the optimizer microphone to

the tripod with the attaching screw of the tripod.

4 When the speakers are connected to EXTRA

SP terminals, press oCursor k repeatedly

to select “Extra SP Assign,” and then press

oCursor l / h to select how to use EXTRA

SP terminals from “Zone2,” “Presence” or

“None.”

If this unit does not work when you press oCursor,

press mSETUP once and then operate this unit.

Optimizing the speaker setting for your listening room (YPAO)

Notes

• Be advised that it is normal for loud test tones to be

output during the “Auto Setup” procedure. Do not

allow small children to enter the room during the

procedure.

• To achieve the best results, make sure the room is as

quiet as possible while the “Auto Setup” procedure is

in progress. If there is too much ambient noise, the

results may not be satisfactory.

• See page 44 for the “Manual Setup” procedure.

Using Auto Setup

VOLUME

MIN MAX

CROSSOVER/

HIGH CUT

MIN MAX

Subwoofer

IDE

UDI

RTABLE

VIDE

OPTIMIZER

MIC

Optimizer microphone

1 AutoSetup

>Zone2Presence

ExtraSPAssign

[ENTER]:Start

None

EQ Type;;;;Natural

. Start

[]/[]:Up/Down

[

Optimizer microphone

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 155 156

Commentaires sur ces manuels

Pas de commentaire

Yamaha RX-V665 Manuel du propriétaire Page 21

Commentaires sur ces manuels

Produits connexes et manuels pour Récepteurs AV Yamaha RX-V665