En 30
PLAYBACK
The FM/AM tuner of this unit provides the following
two modes for tuning.
Normal tuning
You can tune in to a desired FM/AM station by searching
or specifying its frequency.
Preset tuning (☞p. 31)
You can preset the frequencies of FM/AM stations by
registering them to specific numbers, and later just select
those numbers to tune in.
Selecting a frequency for reception
(Normal tuning)
1
Press cTUNER to switch to the tuner input.
2
Press dFM or dAM to select a band to
receive.
3
Use dTUNING H / I to set a frequency to
receive.
dTUNING H
Increases the frequency. Press and hold this key for
longer than a second to search automatically for a station
on a higher frequency than the current one. J1
d
TUNING I
Decreases the frequency. Press and hold this key for
longer than a second to search automatically for a station
on a lower frequency than the current one. J1
FM/AM tuning
cTUNER
dFM
dAM
dTUNING H / I
iCursor B / C / D / E
iENTER
mOPTION
OPTION
TUNER
FM AM
TUNING
ENTER
ECEIVER
ENE
ET
L
M
ENHAN
E
R
DE
DE
TRAI
HT
DMI
DI
TRAN
MIT
LEE
X
EMOR
RE
ET
I
TERE
D
VD
ADI
T
D
m
i
c
d
When using the FM/AM tuner, adjust the direction of
the FM/AM antenna connected to this unit to get the
best reception.
SW
C
L
SL SR
R
FM87.50MHz
VOL.
STEREO
TUNED
SW
C
L
SL SR
R
FM98.50MHz
VOL.
Lights up when receiving
a broadcast from a station
Lights up when receiving
a stereo broadcast
■ When signal reception is poor
When you are receiving an FM broadcast and cannot
obtain a stable stereo broadcast, you can force this
unit to receive in a monaural mode.
1
Press cTUNER to switch to the tuner
input.
2
Press mOPTION to display the Option
menu. J2
3
Use iCursor B / C to select “FM Mode.”
4
Press iENTER and use the iCursor D /
E to select “Mono.”
5
When setting is completed, press
mOPTION to close the Option menu.
To return this unit to its original settings, use the
same procedure to return the settings to “Stereo.”
FMMode
OPTION
VOL .
FMMode:Mono
9850
VOL.
J
1 : When searching for a station, release the key once the search has
started.
J
2 : See the section on “Configuring the settings specific for each
input source (Option menu)” for details on the Option menu
(☞
p. 39).
Commentaires sur ces manuels