Yamaha DSP-A3090 Manuel du propriétaire télécharger pdf (Page 38)

3. For the front effect speaker level adjustment, depress the TEST

switch on the remote control again so that “TEST DSP” appears on

the display panel. A calibration signal should be heard from the main

speakers and the front effect speakers in turn (see diagram).

* Pressing the parameter + or – key (only when the

PARAMETER/SET MENU switch is set to the PARAMETER

position) transfers the test-tone from the speaker that is currently

outputting the test-tone to the front effect speakers. Pressing “+”

transfers the test-tone to the right front effect speaker, and “–” to

the left front effect speaker.

* Pressing and holding the parameter select ▼▼ or ▲▲ key (only

when the PARAMETER/SET MENU switch is set to the

PARAMETER position) fixes the test-tone on the speaker that is

currently outputting the test-tone.

4. Adjust the front level by using the FRONT LEVEL +/– keys on the

remote control so that the speaker volume is the same as that of the

main speakers.

When this adjustment is finished, press the TEST switch once

again.

NOTE: Once you have completed these adjustments, use only

VOLUME control of this unit or MASTER VOLUME keys of the

remote control unit to adjust the whole listening volume. Do not

change any other volume setting in the system.

Main Front

MAIN FRONT

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 73 74

Pas de commentaire

Yamaha DSP-A3090 Manuel du propriétaire Page 38