Yamaha 2012 V Star 250 Manuel du propriétaire Page 74

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 98
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 73
PERIODIC MAINTENANCE AND ADJUSTMENT
7-38
7
EAU25080
Rear wheel
EAU52340
To remove the rear wheel
WARNING
EWA10821
To avoid injury, securely support the
vehicle so there is no danger of it
falling over.
1. Fully loosen the drive chain puller
locknut and the drive chain slack
adjusting nut on both ends of the
swingarm.
2. Loosen the axle nut and the brake
torque rod nut at the brake shoe
plate.
3. Lift the rear wheel off the ground
according to the procedure on
page 7-35.
4. Remove the brake pedal free play
adjusting nut, and then disconnect
the brake rod at the brake cam-
shaft lever.
5. Disconnect the brake torque rod
from the brake shoe plate by re-
moving the nut and the bolt.
6. Push the wheel forward, and then
remove the drive chain from the
rear sprocket.
TIP
The drive chain does not need to be
disassembled in order to remove and
install the rear wheel.
7. Remove the axle nut.
8. Pull the wheel axle out, and then
remove the wheel.
EAU52350
To install the rear wheel
1. Install the drive chain onto the rear
sprocket, and then install the
wheel by inserting the wheel axle
from the right-hand side.
2. Install the brake rod into the brake
camshaft lever, and then install the
brake pedal free play adjusting nut
onto the brake rod.
3. Connect the brake torque rod to
the brake shoe plate by installing
the bolt and nut.
4. Install the axle nut.
5. Lower the rear wheel so that it is
on the ground, and then put the
sidestand down.
1. Axle nut
2. Drive chain puller locknut
3. Drive chain slack adjusting nut
1. Brake torque rod
2. Brake torque rod bolt and nut
3. Brake rod
4. Brake pedal free play adjusting nut
5. Brake camshaft lever
U46B13E0.book Page 38 Monday, September 12, 2011 1:30 PM
Vue de la page 73
1 2 ... 69 70 71 72 73 74 75 76 77 78 79 ... 97 98

Commentaires sur ces manuels

Pas de commentaire