Yamaha YSP-1400 Manuel télécharger pdf (Page 18)

2 While the test-tone is output from the channel to be adjusted, press

the SUBWOOFER key (+ or –) to balance the volume level with the

other channels.

During volume adjustment, the cycle of the test tone stops. When you have finished

adjusting the current channel level, release the + or – key and wait a moment for

the test-tone cycle to resume. You can check the volume level by the indicator

lights.

3 After adjustment is complete, press the CH LEVEL key again.

The test-tone stops.

HINT

• Press the VOLUME key (+ or –) to adjust the overall volume while the test-tone is being played back.

• When the YSP position setting is changed (p.9), the channel level setting will be overwritten.

The unit has dual built-in subwoofers; however you can connect an external subwoofer

when you want to enhance low frequency sound. Perform the following steps to change

the setting when using an external subwoofer.

1 Connect the unit to the external subwoofer with a pin cable.

2 With the unit turned off, hold down the SUBWOOFER (-) key on the

supplied remote control for more than 5 seconds.

The unit turns on and the external subwoofer is selected.

You can check the status of the subwoofer setting by the indicator when turning on

the unit.

To select the built-in subwoofers again, hold down the SUBWOOFER (+) key of the

remote control for more than 5 seconds.

NOTE

• The default output setting is for the built-in subwoofers.

• Use an external subwoofer with built-in amplifier.

Using an external subwoofer

Mono input

Off (external subwoofer), lights up (built-in subwoofer)

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 49 50

Pas de commentaire

Yamaha YSP-1400 Manuel Page 18