Yamaha YSP-1400 Manuel télécharger pdf (Page 17)

When the TV Remote Repeater function is enabled, the unit receives TV remote control

signals at the TV remote control sensor (on front) and transmits the signals from the TV

Remote Repeater (on rear). This function is useful when you cannot operate your TV

from the remote control because the remote control sensor of the TV is blocked by the

unit.

NOTE

• This function is available only when your TV remote control uses infrared signals.

1 Turn on the unit.

2 Hold down the REPEATER key on the supplied remote control for

more than 3 seconds to enable/disable the TV Remote Repeater

function.

This completes the necessary settings. When the TV Remote Repeater function is

enabled, you can operate your TV from the TV remote control via the unit.

HINT

• The TV Remote Repeater function is disabled by default.

• If the power cable of the unit is connected to an AC wall outlet and when the TV Remote Repeater

function is enabled, the function is usable even when the unit is turned off.

• If you have made the unit learn the volume (+) operation (p.14), the volume of the TV may be turned

up when you turn up the volume of the unit with the TV remote control. In this case, follow Step 3 in

“Connections” (p.6) to change the TV setting.

• You can check the status of the TV Remote Repeater function by the center indicator when turning

on the unit.

The surround effects is achieved using six channels (audio outputs) of the unit. While

listening to a series of test-tones from the unit, you can adjust the volume level of each

channel to balance the sound heard from your listening position.

1 Hold down the CH LEVEL key on the remote control for more than 3

seconds.

The STATUS indicator flashes in green during test-tone output. The test-tone

cycles through the channels in the order below. The test-tone is output from each

channel in turn for two seconds. You can confirm which channel is playing the test-

tone by the way the indicators flash.

Controlling the TV via the unit (when the TV’s

remote control sensor is blocked)

TV Remote Repeater

TV’s remote control sensor

TV remote control

Flash 3 times (enabled), Flash once (disabled)

Off (enabled), lights up (disabled)

Adjusting the volume level of each channel (CH

LEVEL)

Test-tone flow

Front (left)

Center

Front (right)

Surround (right)

Surround (left)

Subwoofer

Back to beginning

Continued

➜

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 49 50

Commentaires sur ces manuels

Pas de commentaire

Yamaha YSP-1400 Manuel Page 17

Commentaires sur ces manuels

Produits connexes et manuels pour Non Yamaha YSP-1400