Yamaha DRCX Manuel d'utilisateur télécharger pdf (Page 54)

CHAPTER 4 Installation

4-8

3-3 Adjustment of Z axis tip belt tension (YP220BX, YP220BXR)

1) Turn off the controller power.

2) Remove the robot Z axis cover.

3) Loosen the bolt securing the belt tensioner as shown in Fig. 4-4 and loosen

the belt.

4) Screw the M6 bolt into the hole located beneath the belt tensioner (L-shaped

metal plate) to apply tension to the belt.

5) Apply a load of 0.5 kgf to the center section of the belt for fixing the belt

tension. A slack of approximately 2mm is satisfactory.

6) If the belt tension in now satisfactory, tighten the bolts securing the belt

tensioner.

7) Install the Z axis cover for the robot.

Approx. 2mm

Load 0.5kg

M6 bolt

Securing bolt

Belt tensioner

Fig. 4-4 Belt tension

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 109 110

Pas de commentaire

Yamaha DRCX Manuel d'utilisateur Page 54