Yamaha RX-V620RDS Manuel d'utilisateur télécharger pdf (Page 61)

English

INTRODUCTION

PREPARATION

BASIC OPERA-

TION

ADVANCED

OPERATION

ADDITIONAL

INFORMATION

APPENDIX

SOUND FIELD PROGRAM PARAMETER EDITINGSOUND FIELD PROGRAM PARAMETER EDITING

Changing Parameter Settings

Although it is possible to enjoy playback on your system

without changing default setting parameters for the sound

field program, it is also possible to enjoy specifically

tailor the sound field program to the characteristics of the

source and the acoustics of the listening room.

1 Set the selector dial to the DSP/TUN (or

AMP/TUN) position.

2 Turn on the video monitor

and press ON SCREEN

repeatedly to select the

full display mode.

3 Select a DSP program you want to adjust.

A/B/C/D/E

Program No. Program name (group)

Cursor

Parameters

Example of the MOVIE THEATER 1

4 Press u/d to select the

parameter.

5 Press j / i to change the

parameter value.

• When you set the parameter to a value other than the factory-

set value, an asterisk mark (*) appears by the parameter name

on the video monitor.

6 Repeat steps 3 to 5 above as necessary to

change other program parameters.

Memory back-up

The memory back-up circuit prevents the stored data

from being lost even if this unit is set in the standby

mode, the power cord is disconnected from the AC

outlet, or the power supply is temporarily cut due to

power failure. However, if the power is cut for more

than one week, the parameter value you edited will

return to the factory setting. If so, edit the parameter

value again.

Resetting a Parameter to the

Factory-set Value

Select the parameter you want to reset. Then press and

hold j or i until the value temporarily stops at the

factory-set value. The asterisk mark (*) by the parameter

name disappears on the video monitor.

Notes

• The available parameters may be displayed on more than one

OSD page for some of the programs. To scroll through pages,

press u/d.

• You cannot change parameter values when “10 MEMORY

GUARD” on the SET MENU is set to ON. If you want to

change the parameter values, set “10 MEMORY GUARD” to

OFF.

P07 MOVIE THEATER 1

P. INIT. DLY • • 13ms

70mm Spectacle

S. DELAY

• • • • • 23ms

P. ROOM SIZE • • 1.0

S. ROOM SIZE • • 1.0

0111V620RDS_58-62_EN 1/18/1, 7:27 PM59

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 81 82

Commentaires sur ces manuels

Pas de commentaire

Yamaha RX-V620RDS Manuel d'utilisateur Page 61

Commentaires sur ces manuels

Produits connexes et manuels pour Récepteurs et amplificateurs Yamaha RX-V620RDS