Yamaha RX-V620RDS Manuel d'utilisateur télécharger pdf (Page 32)

TUNING

Connecting the Antennas

Both AM and FM indoor antennas are included with this unit. In general, these antennas should provide sufficient signal

strength.

Connect each antenna correctly to the designated terminals.

Indoor FM

antenna

(included)

AM loop

antenna

(included)

Ground (GND terminal)

For maximum safety and

minimum interference, connect

the antenna GND terminal to a

good earth ground. A good earth

ground is a metal stake driven

into moist earth.

■ Connecting the indoor FM

antenna

Connect the included indoor FM antenna to the FM ANT

75Ω UNBAL. terminal.

Note

• Do not connect an outdoor FM antenna and the indoor FM

antenna at the same time.

■ Connecting the AM loop antenna

1 Press and hold the tab to unlock the terminal

hole.

2 Insert the AM loop antenna lead wires into

the AM ANT and GND terminals.

AM ANT GND

FM ANT

UNBAL.

TUNER

Antenna stand

3 Release the tab to lock the lead wires.

Lightly pull the lead wires to confirm a good

connection.

4 Attach the loop antenna to the antenna

stand.

5 Orient the AM loop antenna so that the best

reception is obtained.

• The AM loop antenna can be removed from the stand and

attached to a wall, etc.

Notes

• The AM loop antenna should be placed away from this unit.

• The AM loop antenna should always be connected, even if an

outdoor AM antenna is connected to this unit.

A properly installed outdoor antenna provides clearer

reception than an indoor one. If you experience poor

reception quality, an outdoor antenna may improve the

quality. Consult the nearest authorized YAMAHA

dealer or service center about the outdoor antennas.

Connecting a coaxial cable to the included

75-ohm/300-ohm antenna adapter (U.K. model

only)

11 (7/16)

8 (5/16)

6 (1/14)

Cover

Unit: mm

(inch)

Lead wire

Clamp with

pliers.

Clamp

with

pliers.

Insert the wire

into the slot.

Open the cover of the

included 75-ohm/300-ohm

antenna adapter.

Cut the external sleeve of

the 75-ohm coaxial cable

and prepare it for

connection.

Cut the lead wire and

remove it.

Insert the cable wire into the

slot, and clamp it with

pliers.

Snap the cover into

place.

0106V620RDS_30-34_EN 1/18/1, 7:25 PM30

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 81 82

Commentaires sur ces manuels

Pas de commentaire

Yamaha RX-V620RDS Manuel d'utilisateur Page 32

Commentaires sur ces manuels

Produits connexes et manuels pour Récepteurs et amplificateurs Yamaha RX-V620RDS