Yamaha Tyros5 Manuel du propriétaire télécharger pdf (Page 89)

Tyros5 Owner’s Manual 89

Microphone – Adding Harmony Vocals and Synth Vocoder to Your Singing –

5 Adjust the volume balance between the microphone sound and

the instrument sound on the BALANCE display (page 61).

This section covers the Vocal Harmony Effects that can be applied to your voice via the microphone sound.

1 Connect the microphone to the instrument (page 88).

2 Press the [VH TYPE SELECT] button to call up the Vocal Har-

mony Type Selection display.

3 Use the TAB [][] buttons to select the VOCAL HARMONY

tab.

4 Use the [A]–[J] buttons to select the desired Vocal Harmony

type.

The Vocal Harmony features three different Modes which can be selected auto-

matically by selecting a Vocal Harmony type.

5 If necessary, press the [VOCAL HARMONY] button to turn the

function on.

Disconnecting the microphone

1 Set the [MIC GAIN] knob to the minimum position.

2 Disconnect the microphone from the [MIC INPUT] jack.

Using Vocal Harmony

Icon Mode Descriptions

(Microphone)

Chordal The harmony notes are determined by the chords you play in the chord sec-

tion (with [ACMP] turned on), the left hand section (with [ACMP] turned off

and [LEFT] turned on) or the chord data of a Song.

(Microphone with FX)

The harmony notes are determined in the same way as in Microphone above.

However, effects such as Vocal Doubler and Short Delay are applied. Har-

mony may or may not be applied depending on the selected type. (If har-

mony is not applied, the [VOCAL HARMONY] button is not lit.)

(Microphone and keyboard)

Vocoder The microphone sound is output via the notes you play on the keyboard or

via the Song playback notes.

Vocoder-Mono Same as the Vocoder basically. In this mode, only single-note melodies or

lines can be played back (with last-note priority).

1 2 ... 84 85 86 87 88 89 90 91 92 93 94 ... 127 128

Pas de commentaire

Yamaha Tyros5 Manuel du propriétaire Page 89