Yamaha NS-9900 Manuel du propriétaire télécharger pdf (Page 2)

2 En

When placing the speakers, be sure to use the stands to

increase stability.

• The provided stands are in two types. Two stands are

for the right side and others are for the left side. Attach

each stand to the proper position on the bottom of the

speaker by following the figure below.

• When attaching the stands to the speaker, have another

person support it.

• To attach the stands to the speaker, be sure to lay down

the speaker while the front is facing up. We recommend

using a blanket or cushion (thickness of 3 cm or more)

to raise the speaker from the floor.

Use the 8 specified holes located on the base of the speaker.

How to attach

1 Put a screw through a washer, then through the

inner hole of the stand, and screw it into the outside

hole of the speaker. Do not tighten too much at this

point.

2 Put a screw through a washer, then through the

outer hole of the stand, and screw it into the other

hole on the base of the speaker.

3 Tighten both of the screws firmly.

4 Attach a pad to the bottom of the end portion of the

stand.

5 Attach the other stands to the other corners of the

base of the speaker in the same way and confirm

that all 4 stands have been firmly attached.

Be careful not to apply force to the side of the speaker,

otherwise the speaker may fall causing damage to the

speaker or personal injury.

SUPPLIED ACCESSORIES

Speaker cable

(4 m) x 1

Stand

(R x 2, L x 2)

Screw

(M4, 25 mm)

x 8

Non-skid pad

(1 set: 4 pcs)

Washer x 8

ATTACHING THE STANDS

Notes

(L) (R)

(R) (L)

Front

Back

View from the bottom of the speaker

Note

Outer hole

Inner hole

1 2 3 4 5 6 7 ... 21 22

Commentaires sur ces manuels

Pas de commentaire

Yamaha NS-9900 Manuel du propriétaire Page 2

Commentaires sur ces manuels

Produits connexes et manuels pour Haut-parleurs pour voitures Yamaha NS-9900