Yamaha RX-A2000 Manuel du propriétaire Page 123

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 159
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 122
SETUP
Extended functionality that can be configured as needed (Advanced Setup menu)
En 123
Changing TV format
Change the color encoding format of OSD to PAL or NTSC
(default), to match the format used by the TV connected via the
HDMI OUT 1-2 or VIDEO (MONITOR OUT) jack.
Removing HDMI video output up-scaling
limits
Removes the up-scaling limitation on video resolution when this
unit and a TV are connected via HDMI jacks.
If a resolution supported by the monitor cannot be detected when
configuring the up-scaling settings, this setting will remove the
output limitation.
Recovery and backup of the system
settings
Save and restore the settings of this unit.
1
Press STRAIGHT repeatedly to select “BACKUP” or
“RECOVERY” and press INFO on the front panel.
2
Press INFO to execute the “BACKUP” or
“RECOVERY.J1
Initializing various settings for this unit
Initializes various settings stored in this unit and sets it back to
default.
Select the items to be initialized from the following.
When an option other than CANCEL is selected, the applicable
default settings will be restored when the unit switches to standby
mode.
YES (Default) Video output signals of a resolution not supported by
the TV will not be transmitted.
SKIP This unit ignores the TV’s support capability and
transmits input video signals to the TV.
TVFORMAT

NTSC
MONITORCHECK

YES
RECOVERY Restores settings for this unit that have been saved.
BACKUP Saves the current settings of this unit.
“RECOVERY” cannot be selected if settings have not be
previously saved.
RECOV./BACKUP

BACKUP
STRAIGHT
INFO
DSP PARAM Initializes all parameters for the sound programs.
VIDEO Resets video conversion settings (resolution/aspect
ratio) in the Setup menu.
NETWORK Resets the settings of network such as IP address or
the account of vTuner.
ALL Resets this unit to default factory settings.
CANCEL (Default) Does not initialize.
INITIALIZE

CANCEL
J
1 : After performing “RECOVERY,” turn off this unit.
Vue de la page 122
1 2 ... 118 119 120 121 122 123 124 125 126 127 128 ... 158 159

Commentaires sur ces manuels

Pas de commentaire