Yamaha NS-U40P Manuel du propriétaire télécharger pdf (Page 4)

m Mounting the speakers on a wall

The speakers can also be hung on the wall.

Fasten screws into a firm wall or wall support as shown in

the figure, and hang the slits on the rear of the speaker on

the protruding screws.

* Make sure that the screws are securely caught by the

slits.

Warning

● Each speaker weighs 0.3 kg (0.6 lbs.). Do not mount them

on thin plywood or a wall with soft surface material. If

mounted, the screws may come out of the flimsy surface

and the speakers may fall. This could damage the speakers

and cause personal injury.

● Do not install the speakers on a wall with nails, adhesives,

or any other unstable hardware. Long-term use and

vibrations may cause them to fall.

● To avoid accidents resulting from tripping over loose

speaker cables, fix them to the wall.

m Placing the center speaker on top of the

monitor

A speaker used for the center speaker can be placed on top

of the monitor. Follow one of the two procedures below for

placing a speaker on top of the monitor.

Placing the center speaker on top of the monitor

by using the provided fastener

First remove the stand from the speaker, and attach the

provided fastener at the bottom of the speaker and on top of

the monitor to prevent the speaker from falling.

* This is the recommended method for placing a speaker

on top of the monitor. If discoloration of picture occurs, or

you need the speaker stand to adjust the speaker angle

on top of the monitor, you can select the following

method.

Tapping screw (4 mm)

(Available in hardware stores)

50 mm

Min.

20 mm

4 mm

Wall/ wall

support

Note

Do not place the speaker on top of the monitor with an

inclination of more than 10 degrees.

Placing the center speaker on top of the monitor

with the speaker stand attached to the speaker

In this method, you need to fix the speaker cable on the

monitor by using the provided cable holder to prevent the

speaker from falling.

1 Remove the backing sheet from the holder, and attach

the holder on top of the monitor by pressing it down

forcibly. (The top of the monitor must be cleaned

beforehand.)

2 Tie the speaker cable to the holder firmly with a provided

vinyl-coated wire (which is originally used for bundling

the speaker cables) as shown below.

Note

Though this speaker is a magnetically shielded type, there

may be some influence on the monitor picture depending on

the type of monitor or the placement of the speaker. In such a

case, place the speaker further apart from the monitor until

there is no influence on the monitor picture.

Fastener

10&

Cable holder

Vinyl-coated wire

E-2

1 2 3 4 5 6 7 8 9 ... 23 24

Commentaires sur ces manuels

Pas de commentaire

Yamaha NS-U40P Manuel du propriétaire Page 4

Commentaires sur ces manuels

Produits connexes et manuels pour Haut-parleurs Yamaha NS-U40P