Yamaha RX-V390RDS Manuel du propriétaire télécharger pdf (Page 9)

English

How to Connect:

Connect the SPEAKERS terminals to your speakers with wire

of the proper gauge, cut as short as possible. If the

connections are faulty, no sound will be heard from the

speakers. Make sure that the polarity of the speaker wires is

correct, that is, + and – markings are observed. If these wires

are reversed, the sound will be unnatural and will lack bass.

Do not let the bare speaker wires touch each other and do

not let them touch the metal parts of this unit as this could

damage this unit and/or speakers.

For connecting to the FRONT SPEAKERS terminals

Red: positive (+)

Black: negative (–)

➀

Unscrew the knob.

➁

Insert the bare wire.

[Remove approx. 5mm

(1/4”) insulation from

the speaker wires.]

➂

Tighten the knob and

secure the wire.

Note

●

Use speakers with the specified impedance shown on the

rear of this unit.

For connecting to the REAR and CENTER SPEAKERS

terminals

Red: positive (+)

Black: negative (–)

➀

Press the tab.

➁

Insert the bare wire.

[Remove approx. 5mm

(1/4”) insulation from

the speaker wires.]

➂

Release the tab and

secure the wire.

➁

➂

➀

ABOUT THE ACCESSORY TERMINALS

AC OUTLET(S) (SWITCHED)

(Europe model) ................................. 2 SWITCHED OUTLETS

(U.K. model) ........................................ 1 SWITCHED OUTLET

Use these to connect the power cords from your components

to this unit.

The power to the SWITCHED outlets is controlled by this unit’s

POWER switch or the provided remote control transmitter’s

POWER key. These outlets will supply power to any

component whenever this unit is turned on.

The maximum power (total power consumption of

components) that can be connected to the SWITCHED AC

OUTLET(S) is 100 watts.

CENTER OUTPUT terminal

This terminal is for center channel line output. There is no

connection to this terminal when you use the built-in amplifier.

However, if you drive a center speaker with an external power

amplifier, connect the input terminal of the external amplifier to

this terminal.

GND terminal (For turntable use)

Connecting the ground wire of the turntable to the GND

terminal will normally minimize hum, but in some cases better

results may be obtained with the ground wire disconnected.

Use one of the two GND terminals on the rear of this unit for

the connection.

ANT

GND

75Ω

UNBAL

GND

Turntable

Loosen Tighten

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 33 34

Commentaires sur ces manuels

Pas de commentaire

Yamaha RX-V390RDS Manuel du propriétaire Page 9

Commentaires sur ces manuels

Produits connexes et manuels pour Lecteurs de cassettes Yamaha RX-V390RDS