Yamaha WX-030 Manuel du propriétaire télécharger pdf (Page 18)

14 En

You can update the firmware only when the unit is connected to the Internet (☞ P.6).

Follow the instructions in the MusicCast CONTROLLER app to update.

The power indicator flashes quickly while the firmware is being updated.

Updating completed: The unit restarts.

Updating failed: All the indicators flash. Unplug the power cable from the wall outlet and plug it in after 30 seconds or more,

then update the firmware again.

• Do not operate the unit or disconnect the power cable or network cables while updating.

• Do not turn off the unit (enter standby mode) while updating the firmware.

• The update of the firmware will be informed in the app.

• When Internet speed is not fast enough or the unit is connected to the wireless network via a wireless network adapter,

network update may not be possible depending on the condition of the wireless connection.

To set the following option settings, set this unit to the standby mode, and touch and hold and for 5 seconds.

*1: If you do not tap any button during these 5 seconds, the unit will cancel the option setting mode.

*2: Network Standby is a standby mode which enables the unit to connect to the network by operating another device.

Eco Standby

You can only enable/disable Network Standby mode in the option settings as long as the unit is in Eco Standby mode.

If you disable Network Standby, the unit enters Eco Standby mode, which keeps the standby power consumption to a

minimum. However, you cannot start up the unit with the MusicCast CONTROLLER app during Eco Standby mode.

UPDATING THE FIRMWARE

OPTION SETTINGS

Items Operations

Initialize the network setting.

Touch and hold (power)/CONNECT for 3 seconds (☞ P.3).

Enable/disable Network Standby

mode.

A Touch and hold for 3 seconds. Network Standby will be disabled. To enable it, perform the same

operation.

Enable: The power indicator flashes twice and remains lit.

Disable: The power indicator flashes twice and turns off.

B Tap (power)/CONNECT once to turn on the unit.

The setting is complete.

Enable/disable Wi-Fi.

Touch and hold for 3 seconds. Wi-Fi will be disabled. To enable it, perform the same operation.

Enable: The network indicator flashes twice and remains lit.

Disable: The network indicator flashes twice and turns off.

Enable/Disable Bluetooth.

Touch and hold for 3 seconds. Bluetooth will be disabled. To enable it, perform the same operation.

Enable: The Bluetooth indicator flashes twice and remains lit.

Disable: The Bluetooth indicator flashes twice and turns off.

Note

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 75 76

Pas de commentaire

Yamaha WX-030 Manuel du propriétaire Page 18