Yamaha NS-SW901 Manuel Page 9
- Page / 84
- Table des matières
- DEPANNAGE
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
6 En
English
See pages 6 - 7 when your amplifier has subwoofer (line out) terminal(s), or see pages 8 - 10 when your amplifier has no
subwoofer (line out) terminal.
• Do not connect the power cord of this unit and other components into an AC outlet until all connections between
components are completed.
• Be sure to connect the left channel (L), right channel (R), “+” (red) and “–” (black) properly. Also, refer to the owner’s
manual of your component to be connected to this unit.
• The connection methods or the names of the terminals may differ depending on the component. Refer to the owner’s
manual of your component as well.
When your amplifier has a one-channel subwoofer terminal
Connect the subwoofer (or low pass etc.) terminal of your amplifier to the INPUT 3 ( /MONO) terminal of this unit
using a commercially available mono pin cable.
When your amplifier has two-channel subwoofer terminals
■ Using one subwoofer
Connect the “L” side subwoofer terminal of your amplifier to the INPUT 3 ( /MONO) terminal of this unit and “R” side
subwoofer terminal of your amplifier to the INPUT 3 ( ) terminal of this unit using a commercially available audio pin
cable.
• Some amplifiers have line output terminals labeled PRE OUT. When you connect this unit to the PRE OUT terminals
of the amplifier, make sure that the amplifier has at least two sets of PRE OUT terminals. If the amplifier has only one
set of PRE OUT terminals, do not connect this unit to the PRE OUT terminals. Instead, connect this unit to the speaker
terminals of the amplifier (see pages 8 - 9).
• When connecting to a monaural line output terminal of the amplifier, connect the INPUT 3 ( /MONO) terminal.
• When connecting to line output terminals of the amplifier, other speakers should not be connected to the OUTPUT
terminals on the rear panel of this unit. If connected, they will not produce sound.
CONNECTIONS
Notes
Connecting to the amplifier equipped with subwoofer (line out) terminal(s)
Notes
1
L
OUTPUT
TO SPEAKERS
FROM AMPLIFIER
L
L
L
R
R
R
LR
MONO
INPUT
3
INPUT
2
INPUT 1
OUTPUT
TO SPEAKERS
FROM AMPLIFIER
INPUT
3
INPUT
2
INPUT 1
L
L
L
R
R
R
LR
MONO
POWER
ON
OFF
Amplifier
Mono pin cable (not included)
Subwoofer
L
R
L
OUTPUT
TO SPEAKERS
FROM AMPLIFIER
L
L
L
R
R
R
LR
MONO
INPUT
3
INPUT
2
INPUT 1
OUTPUT
TO SPEAKERS
FROM AMPLIFIER
INPUT
3
INPUT
2
INPUT 1
L
L
L
R
R
R
LR
MONO
POWER
ON
OFF
Audio pin
cable
(not included)
Amplifier
Subwoofer
- NS-SW901 1
- CONTENTS 3
- GETTING STARTED 4
- Controls and functions 5
- 3 Close the battery cover 7
- PLACEMENT 8
- CONNECTIONS 9
- ■Using two subwoofers 10
- ■ Banana plug connection 11
- ■Using one subwoofer 12
- ■ Using one subwoofer 13
- ■ Using two subwoofers 13
- Connecting the power cable 14
- USING THIS UNIT 15
- 3 Press PRESET 1 16
- 2 Press MEMORY 16
- ■ Setting 17
- ■ Canceling 17
- Frequency response 18
- TROUBLESHOOTING 20
- SPECIFICATIONS 21
- CONTENIDO 23
- PRIMEROS PASOS 24
- Controles y funciones 25
- Cambio de las pilas 27
- Manejo del mando a distancia 27
- Orientación del subwoofer 28
- CONEXIONES 29
- Conexión del cable de 34
- USO DE ESTA UNIDAD 35
- 2 Pulse MEMORY 36
- 3 Pulse PRESET 1 36
- ■ Ajuste 37
- ■ Cancelación 37
- Características de frecuencia 38
- SOLUCIÓN DE PROBLEMAS 40
- ESPECIFICACIONES 41
- 注意事项：操作本装置前敬请阅读。 42
- 1，2 或 3 之外的按钮，或当你操作 45
- (LFE) 端子 46
- 1 按下电池盒盖上的 标记，打开盒盖。 47
- 3 关闭电池盒盖。 47
- 超低音扬声器摆放方向 48
- 连接到具有超低音扬声器 （线输出）端子的放大器 49
- ■使用两个超低音扬声器 50
- ■连接到具有高频截去功能的放大器 50
- + 和 - 准确无误。 如果这些 51
- 连接到没有装备有超低音扬声器 （线输出）端子的放大器 51
- 当你的放大器具有一套前扬声器端子时 52
- ■使用一个超低音扬声器 52
- ■ 使用一个超低音扬声器 53
- ■ 使用两个超低音扬声器 53
- ■ VOLTAGE SELECTOR （电压选择器）开关 54
- （仅适用于亚洲及一般机型号） 54
- HIGH CUT / ，调节到可以得到期望反 55
- 1 在音量, 高频截去,位相以及B.A.S.S.之间调节 56
- 2 按 MEMORY。 56
- 3 按下 PRESET 1。 56
- 1 设置后面板的电源开关到关位置。 57
- 2 在按住前面板的 STANDBY/ON 开关的同时，设 57
- 2 在按住前面板的 STANDBY/ON 开关的同时，设置 57
- H-CUT 140 Hz 58
- NS-SW901 (H-CUT 60 - 70 Hz) 58
- NS-SW901 (H-CUT 50 - 60Hz) 58
- 서브우퍼 ( 라인 출력 ) 터미널이 장착된 63
- 본 설명서에 대하여 64
- 각부 명칭 및 기능 65
- 1 건전지 덮개의 표시를 눌러 덮개를 엽니다 67
- 3 건전지 덮개를 닫습니다 67
- : 서브우퍼 : 프론트 스피커 68
- 앰프에 한 개의 채널 서브우퍼 터미널이 있는 경우 69
- 앰프에 두 개의 채널 서브우퍼 터미널이 있는 경우 69
- ■ 하나의 서브우퍼 사용 69
- ■두 개의 서브우퍼 사용 70
- ■고주파 차단 기능이 장착된 앰프에 연결 70
- ■ 스피커 케이블에 연결 71
- ■ 바나나 플러그 연결 71
- 앰프에 한 세트의 프론트 스피커 터미널이 있는 경우 72
- ■하나의 서브우퍼 사용 72
- ■ 두 개의 서브우퍼 사용 73
- 접지 터미널에 연결 74
- 전원 케이블 연결 74
- 본 기기 사용법 75
- 2 MEMORY 를 누릅니다 76
- 3 PRESET 1 을 누릅니다 76
- 1 후면 패널의 POWER 스위치를 OFF 위치로 설 77
- 2 전면 패널의 STANDBY/ON 스위치를 누른 상 77
- 본 기기의 주파수 특성 78
- 본 기기의 리모콘 신호 수신기와 리모콘 사 80
- 이에 장애물이 있습니다 80
- 장애물을 제거하십시오 80
- Printed in Indonesia ZH67610 84
- © 2013 Yamaha Corporation 84
Produits connexes et manuels pour Subwoofers Yamaha NS-SW901
Subwoofers Yamaha NS-SW700 Manuel
(21 pages)
(21 pages)
Subwoofers Yamaha YST-SW500 Manuel
(15 pages)
(15 pages)
© 2020, manymanuals.fr. Tous droits réservés | 0.552 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels