Yamaha 150 Manuel d'utilisateur télécharger pdf (Page 8)

Caution for Connection

1. Turn off the POWER switch.

2. Remove the cover attachment screws and remove the

protective cover from the speaker terminals.

Screw

3. After removing approx. 15 mm of insulation from the

ends of the speaker cables, bind the bare ends of the

speaker wires in the corresponding speaker terminals

and tighten the terminals to securely clamp the wires.

Refer to page 5 for speaker porality.

15mm*

* Shown actual size.

At this time make sure that the bare ends of the

speaker cables do not extend from the terminals in

such a way that they touch the chassis.

Wire should not

touch the chassis.

4. Reattach the protective cover over the speaker

terminals.

1 2 3 4 5 6 7 8 9 10 11 12 13

Pas de commentaire

Yamaha 150 Manuel d'utilisateur Page 8