Yamaha RX-V395 Manuel du propriétaire télécharger pdf (Page 43)

English

Returning to the factory-set

codes

To return all components to the factory-set

codes, follow these steps.

1. Press a component selector button

other than AMP<TUNER>.

2. Press both VOLUME buttons ( )

for about four seconds at the same

time so that the indicator flashes

twice.

3. Enter the code number “9990”.

4. Make sure that the indicator flashes

twice.

To return each component to the factory-

set codes, follow these steps.

1. Press the component selector that

matches the component to be

returned to the factory-set codes.

2. Press both VOLUME buttons ( )

at the same time for about four

seconds so that the indicator flashes

twice.

3. Enter the code number “0000”.

4. Make sure that the indicator flashes

twice.

The following codes are preset by the

factory.

Factory-set codes

We recommend that you write all code

numbers you have preset on the “Quick

Reference Card”.

To control your components

(MD recorder, DVD player, TV,

etc.)

1. Turn on the component to be used.

2. Press the component selector button

that matches the component to be

controlled (TAPE/MD, DVD/LD, TV

etc.).

3. Press both VOLUME buttons ( )

at the same time for about four

seconds so that the indicator flashes

twice.

4. Use the numeric buttons to enter the

four-digit manufacturer’s code for the

component to be used. Make sure that

the indicator flashes twice.

If the indicator does not flash, repeat

step 3 and re-enter the code.

5. Press POWER (or any other button)

on the remote control transmitter to

check if you have preset the code

correctly. If the component cannot be

controlled by the remote control

transmitter, try entering another code

for the same manufacturer.

Presetting the remote control transmitter

Perform the presetting procedure for each component you want to control with the remote control transmitter.

Note

If your component does not respond to any of the codes listed for the manufacturer, use the original remote control transmitter that

was supplied with the component.

To use a second (and third)

VCR

You can control a second (and/or third)

VCR in the CBL/DBS and DVD MENU

modes if a CBL (or DBS) or DVD player is

not being used.

If you want to control a second (and/or

third) VCR in the DVD MENU mode, you

must preset the code for an LD player in

that mode.

1. Turn on the VCR to be used.

2. Press the component selector button

CBL/DBS or DVD MENU.

3. Press both VOLUME buttons ( )

at the same time for about four

seconds so that the indicator flashes

twice.

4. Use the numeric buttons to enter the

four-digit code for the second (or third)

VCR. Make sure that the indicator

flashes twice. If the indicator does not

flash, repeat step 3 and re-enter the

code.

5. Press POWER (or any other button)

on the remote control transmitter to

check if you have preset the code

correctly. If the VCR cannot be

controlled by the remote control

transmitter, try entering another code

for the same manufacturer.

SETUP CODES

2CH

6CH

Component Component Code

selector

TV TV 0101

CBL/DBS DBS tuner 0006

VCR VCR 0002

DVD/LD DVD player 0008 YAMAHA

CD CD player 0005 YAMAHA

TAPE/MD Tape deck 0004 YAMAHA

2CH

6CH

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 51 52

Commentaires sur ces manuels

Pas de commentaire

Yamaha RX-V395 Manuel du propriétaire Page 43

Commentaires sur ces manuels

Produits connexes et manuels pour Récepteur Yamaha RX-V395