Yamaha DSP-1 Spécifications télécharger pdf (Page 13)

1 Audio Signal Connection Jacks (for Audio Source Equipment)

Connect the inputs and/or outputs of your audio equipment.

2 Audio/Video Signal Connection Jacks (for Video Source

Equipment)

Connect the audio and video inputs and/or outputs of your video

equipment. In place of the VIDEO jacks, the S VIDEO jacks can

be used for higher resolution and improved picture quality if your

VCR, monitor, etc. are equipped with S-VIDEO connectors.

3 Front Effect Out Jacks

Front-channel line output. Not connected when the built-in

amplifier is used. Can be connected to input jacks of an external

stereo power amplifier driving the front effect speakers.

4 Rear Effect Out Jacks

Rear-channel line output. Not connected when the built-in

amplifier is used. Can be connected to input jacks of an external

stereo power amplifier driving the rear effect speakers.

5 Main Speaker Terminals

When using this unit’s built-in main-channel amplifier, connect the

main speakers here.

6 Front Effect Speaker Terminals

When using the built-in front-channel amplifier, connect the front

effect speakers here.

7 Center Speaker Terminals

When using the built-in center-channel amplifier, connect one or

two center speakers here.

8 Center Speaker Impedance Switch

Set to “A + B” when using two center speakers, or to “A or B”

when using only one center speaker.

9 Rear Effect Speaker Terminals

When using the built-in rear-channel amplifier, connect the rear

effect speakers here.

0 GND Terminal

Connects the ground wire of the turntable to produce minimum

hum. In some cases, however, better results may be obtained

with the ground wire disconnected.

A Video NTSC/PAL Switch (General Model only)

Set this switch to the position corresponding to the standard

that your video equipment employs.

B Front Mix Switch

Set to “OFF” when setting up a full 7 or 6 speaker system, or to

“ON” when setting up a 5 or 4 speaker system.

C Main Level Switch

Normally set to “0 dB”. If desired, you can decrease the main-

channel output level at the MAIN speaker terminals by 10 dB by

setting this switch to “–10 dB”.

D Low Pass Jack

When using a subwoofer, connect its amplifier input to this jack.

Frequencies below 200 Hz from the left main, right main and

center channels are output to this jack.

English

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 47 48

Commentaires sur ces manuels

Pas de commentaire

Yamaha DSP-1 Spécifications Page 13

Commentaires sur ces manuels

Produits connexes et manuels pour Processeurs Yamaha DSP-1