Yamaha CRW2100S Manuel du propriétaire télécharger pdf (Page 28)

Setup Procedures

7 Connect the audio cable between the CRW2100S drive and the

computer’s sound card, or the motherboard’s audio connector if it

has built-in audio. One end of the audio cable has two connectors: a

vertically-mounted type (PH) and a horizontally-mounted type

(MPC). Choose one that matches your sound card’s connector. The

connector at other end of the cable is connected to “AUDIO OUT” of

the CRW2100S drive. Make sure connector’s lug is at the top.

AUDIO OUT

ID SELECT

PARITY

TER MINATOR

BLOCK SIZE

DC INPUT

5V G

RL124G

SCSI

INTERFACE

CONNECTOR

Lug

Sound card

Vertically-mounted

type (PH)

Horizontally-mounted

type (MPC)

Audio cable

n You do not need to connect the audio cable to write audio CDs since the audio is

passed over the SCSI bus. It is required to play back audio CDs on the CRW2100S

drive via the computer’s sound card. However, if a CD-ROM drive is already

connected to the sound card, you should use this drive to play back your audio

CDs. To listen to audio CDs without a computer sound card, connect headphones

or speakers to the headphone jack on the CRW2100S drive’s front panel.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 52 53

Pas de commentaire

Yamaha CRW2100S Manuel du propriétaire Page 28