Yamaha MW12CX Manuel du propriétaire télécharger pdf (Page 6)

Introduction

MW12CX/MW12C Owner’s Manual

Be sure that the mixer’s power switch is in the

STANDBY position.

Use only the included power adaptor (PA-20) or

an equivalent recommended by Yamaha. Use of a

different adaptor may result in equipment dam-

age, overheating, or ﬁre.

Connect the power adaptor to the AC ADAPTOR IN

connector (

q) on the rear of the mixer, and then

turn the fastening ring clockwise (

w) to secure the

connection.

Plug the power adaptor into a standard household

power outlet.

• Be sure to unplug the adaptor from the outlet

when not using the mixer, or when there are

lightning storms in the area.

•To avoid generating unwanted noise, make

sure there is 50 cm or more between the power

adaptor and the mixer.

Press the mixer’s power switch to the ON position.

When you are ready to turn the power off, press the

power switch to the STANDBY position.

Note that trace current continues to ﬂow while the

switch is in the STANDBY position. If you do not plan

to use the mixer again for a long while, please be sure

to unplug the adaptor from the wall outlet.

To prevent loud pops and noises, turn on the power to

your sound gear starting with the sources (instruments,

CD players, etc.) and ending with the power ampliﬁer or

powered speakers.

Example : Instruments, microphones, and CD players

ﬁrst, then the mixer, and ﬁnally the power

ampliﬁer or powered speakers.

When turning off the power to the system, reverse the

order described above.

Before Turning on the Mixer

Turning the Power On/OFF

CAUTION

NOTE

1 2 3 4 5 6 7 8 9 10 11 ... 33 34

Pas de commentaire

Yamaha MW12CX Manuel du propriétaire Page 6