Yamaha CP1 Manuel d'utilisateur Page 10
- Page / 20
- Table des matières
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
10 CP1 Data List
MIDI Data Format
Many MIDI messages listed in the MIDI Data Format section are expressed in hexadecimal or
binary numbers. Hexadecimal numbers may include the letter “H” as a suffix. The letter “n”
indicates a certain whole number.
The chart below lists the corresponding decimal number for each hexadecimal number.
Additional Notes
• For example, 144 – 159 (Decimal)/9nH/1001 0000 – 1001 1111 (Binary) indicate the note-
on messages for the channels 1 through 16 respectively. 176 – 191/BnH/1011 0000 –
1011 1111 indicate the control change messages for the channels 1 through 16
respectively. 192 – 207/CnH/1100 0000 – 1100 1111 indicate the program change
messages for the channels 1 through 16 respectively. 240/F0H/1111 0000 is positioned at
the beginning of data to indicate a system exclusive message. 247/F7H/1111 0111 is
positioned at the end of the system exclusive message.
• aaH (Hexadecimal)/0aaaaaaa (Binary) indicates the data addresses. The data address
consists of High, Mid and Low.
• bbH/0bbbbbbb indicates byte counts.
• ccH/0ccccccc indicates check sums.
• ddH/0ddddddd indicates data/value.
(1) TRANSMIT FLOW
MIDI <-+-[SW1]--+---------NOTE ON/OFF 9nH
OUT | |
| +---------CONTROL CHANGE
| | VOLUME BnH, 07H
| | PAN BnH, 0AH
| | SUSTAIN SWITCH BnH, 40H
| | SOSTENUTO BnH, 42H
| | SOFT PEDAL BnH, 43H
| | EG RELEASE TIME BnH, 48H
| | EG DECAY TIME BnH, 4BH
| | REVERB SEND BnH, 5BH
| | ASSIGNABLE CONTROLLER BnH, (00H .. 5FH)
| | FOOT VOLUME BnH, (07H or 0BH)
| |
| +--[SW7]--BANK SEL MSB BnH, 00H
| | BANK SEL LSB BnH, 20H
| |
| +--[SW8]--PROGRAM CHANGE CnH
| |
| +---------PITCH BEND CHANGE EnH
|
+------------------ACTIVE SENSING FEH
|
+--[SW5]-+---------SYSTEM EXCLUSIVE MESSAGE
| +---------<BULK DUMP>
| | F0H 43H 0nH 7FH 0CH bhH blH ahH amH alH ddH....ddH ccH F7H
| |
| +---------<PARAMETER CHANGE>
| F0H 43H 1nH 7FH 0CH ahH amH alH ddH....ddH F7H
|
+------------------SYSTEM EXCLUSIVE MESSAGE
IDENTITY REPLY
F0H 7EH 7FH 06H 02H 43H 00H 41H 3BH 06H 00H 00H 00H 7FH F7H
[SW1] MIDI Transmit Channel and Transmit Filter
When Keyboard Mode (KbdMode) is set to “zone”, MIDI data is transmitted in line with the Transmit MIDI Switch
(MIDI) settings for each zone and via the corresponding zone transmit channels.
When Keyboard Mode (KbdMode) is set to “layer” or “split”, MIDI data is transmitted via the Transmit Channel
(TransCh).
[SW5] MIDI Device Number
When set to all, transmitted via 1.
[SW7] SYSTEM Bank Select Switch
[SW8] SYSTEM Program Change Switch
(2) RECEIVE FLOW
MIDI>-+-[SW10]-+---------NOTE OFF 8nH
| |
| +---------NOTE ON/OFF 9nH
| |
| +---------CONTROL CHANGE
| | DATA ENTRY MSB BnH, 06H
| | DATA ENTRY LSB BnH, 26H
| | MAIN VOLUME BnH, 07H
| | PAN BnH, 0AH
| | EXPRESSION BnH, 0BH
| | SUSTAIN SWITCH BnH, 40H
| | SOSTENUTO BnH, 42H
| | SOFT PEDAL BnH, 43H
| | EG RELEASE TIME BnH, 48H
| | EG DECAY TIME BnH, 4BH
| | EFFECT1 DEPTH (Reverb) BnH, 5BH
| | DATA ENTRY INC BnH, 60H
| | DATA ENTRY DEC BnH, 61H
| | ASSIGNABLE CONTROLLER BnH, (00H .. 5FH)
| | RPN
| | PITCH BEND SENS. BnH, 64H, 00H, 65H, 00H, 06H, mmH
| | RPN RESET BnH, 64H, 7FH, 65H, 7FH
| | ALL SOUND OFF BnH, 78H
| | RESET ALL CONTROLLERS BnH, 79H
| | ALL NOTE OFF BnH, 7BH
| | OMNI MODE OFF BnH, 7CH
| | OMNI MODE ON BnH, 7DH
| |
| +--[SW7]--BANK SEL MSB BnH, 00H
| | BANK SEL LSB BnH, 20H
| |
| +--[SW8]--PROGRAM CHANGE CnH
| |
| +---------PITCH BEND CHANGE EnH
|
+------------------ACTIVE SENSING FEH
|
+--[SW5]-+---------<BULK DUMP>
| | F0H 43H 0nH 7FH 0CH bhH blH ahH amH alH ddH.....ddH ccH F7H
| |
| +---------<PARAMETER CHANGE>
| | F0H 43H 1nH 7FH 0CH ahH amH alH ddH.....ddH F7H
| |
| +---------<BULK DUMP REQUEST>
| | F0H 43H 2nH 7FH 0CH ahH amH alH ddH.....ddH F7H
| |
| +---------<PARAMETER REQUEST>
| F0H 43H 3nH 7FH 0CH ahH amH alH F7H
|
+-------------------SYSTEM EXCLUSIVE MESSAGE
IDENTITY REQUEST F0H 7EH 0nH 06H 01H F7H
[SW5] MIDI Device Number
When this is not set to off, the MIDI Master Volume can be recognized in any mode.
[SW7] SYSTEM Bank Select Switch
[SW8] SYSTEM Program Change Switch
[SW10] MIDI Receive Channel
When Keyboard Mode (KbdMode) is set to “zone”, Zone 1 receives data on MIDI Channel 1; Zone 2 receives data
on MIDI Channel 2.
When Master Keyboard Mode (KbdMode) is set to “layer” or “split”, MIDI data is received via the Basic Receive
Channel (RecvCh).
Decimal Hexadecimal Decimal Hexadecimal
0 0 64 40
1 1 65 41
2 2 66 42
3 3 67 43
4 4 68 44
5 5 69 45
6 6 70 46
7 7 71 47
8 8 72 48
9 9 73 49
10 0A 74 4A
11 0B 75 4B
12 0C 76 4C
13 0D 77 4D
14 0E 78 4E
15 0F 79 4F
16 10 80 50
17 11 81 51
18 12 82 52
19 13 83 53
20 14 84 54
21 15 85 55
22 16 86 56
23 17 87 57
24 18 88 58
25 19 89 59
26 1A 90 5A
27 1B 91 5B
28 1C 92 5C
29 1D 93 5D
30 1E 94 5E
31 1F 95 5F
32 20 96 60
33 21 97 61
34 22 98 62
35 23 99 63
36 24 100 64
37 25 101 65
38 26 102 66
39 27 103 67
40 28 104 68
41 29 105 69
42 2A 106 6A
43 2B 107 6B
44 2C 108 6C
45 2D 109 6D
46 2E 110 6E
47 2F 111 6F
48 30 112 70
49 31 113 71
50 32 114 72
51 33 115 73
52 34 116 74
53 35 117 75
54 36 118 76
55 37 119 77
56 38 120 78
57 39 121 79
58 3A 122 7A
59 3B 123 7B
60 3C 124 7C
61 3D 125 7D
62 3E 126 7E
63 3F 127 7F
- Data List 1
- Performance List 2
- Piano Block 4
- Modulation Effect Block 6
- -12.0 – +12.0 40 – 88 7
- 8 CP1 Data List 8
- Reverb Block 9
- MIDI Data Format 10
- CP1 Data List 11
- (3) TRANSMIT/RECEIVE DATA 11
- 12 CP1 Data List 12
- MIDI Data Table 13
- 14 CP1 Data List 14
- MIDI PARAMETER CHANGE TABLE 15
- (PERFORMANCE COMMON) 15
- (PERFORMANCE PART) 16
- (MASTER KEYBOARD ZONE) 18
- MIDI Implementation Chart 19
- 208MWTO-D0 20
- Printed in Japan 20
Commentaires sur ces manuels
Produits connexes et manuels pour Claviers MIDI Yamaha CP1
(48 pages)
(16 pages)© 2020, manymanuals.fr. Tous droits réservés | 0.791 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
thanks, interesting read