Yamaha DVD-S1200 Manuel du propriétaire télécharger pdf (Page 27)

Advanced operations

SETUP

SELECT

ENTER RETURN

dBdB

Exit

Test

A A

C A

B A C

(L)

(R)

1234

5678

CANCEL

OPEN/CLOSE

POWER

MARKER

PAG EGROUP

ENTER

VIDEO OFF

PLAY MODE SUBTITLE

AUDIO ANGLE

TOP MENU

ON SCREEN RETURN

SET UP

AUDIO

VIDEO

Changing settings

Speaker setting

[DVD-A] [DVD-V]

Select either “2-channel” or “Multi-channel” to suit the speakers you

have connected. You can change the following settings when you

select “Multi-channel”.

Speaker presence and size

1. Use the cursor buttons [3, 4, 2, 1] to select the item and

press [ENTER].

2. Press the cursor buttons [3, 4] to select the setting and

press [ENTER].

Icon examples: Rear speaker (L)

Large: When the speaker supports low-frequency (under

100 Hz) reproduction.

Small: Select when the speaker does not support low-frequency

reproduction.

The size setting for the main speakers is automatically determined by

the setting for the subwoofer.

Delay time

[DVD-V] (Dolby Digital, center and rear speakers only)

For optimum listening with 5.1-channel sound, all the speakers, ex-

cept for the subwoofer, should be the same distance from the seating

position. If you have to place the center or rear speakers closer to the

seating position, adjust the delay time to make up for the difference.

If distance = (from the center speaker) and ? (from the rear speak-

ers) are the same as or greater than > (from the main speakers),

leave the delay time as “0”, the factory preset.

If either distance = or ? is less than >, find the difference in the

relevant table and change to the recommended setting.

Changing the delay time

1. Use the cursor buttons [3, 4, 2, 1] to select the delay time

box and press [ENTER].

2. Press the cursor buttons [3, 4] to adjust the delay time and

press [ENTER].

Speaker balance

1. Use the cursor buttons [3, 4, 2, 1] to select “Test” and

press [ENTER].

A test signal is output from one speaker at a time, starting with the

main left speaker and proceeding clockwise.

MAIN (L)-)CENTER--)MAIN (R)

REAR (L)(----------------==REAR (R)

2. While listening to the test signal, press the cursor buttons

[3, 4] to adjust the volume of the center and rear speakers

so they are the same apparent volume as the main speakers

(s6 dB to r6 dB).

(The main speakers cannot be adjusted here.)

3. Press [ENTER].

The test signal stops.

Note

³Test signal is effective only when you made analog connection.

When you make digital connection, make adjustment using the test

tone on the amplifier.

³No signal is output for the subwoofer. To adjust its volume, play

something, then return to this screen to adjust to suit your taste.

When you are finished

Use the cursor buttons [3, 4, 2, 1] to select “Exit” and press

[ENTER].

Note

The unit may be unable to output as set here due to limitations im-

posed by the unit itself or the disc being played. (The FL display’s

“P.PCM” indicator lights or “D.MIX” indicator goes out in these

cases.)

Difference

Approx. 50 cm

Approx. 100 cm

Approx. 150 cm

Approx. 200 cm

Setting

1.3 ms

2.6 ms

3.9 ms

5.3 ms

Center speaker

Difference

Approx. 200 cm

Approx. 400 cm

Approx. 600 cm

Setting

5.3 ms

10.6 ms

15.9 ms

Rear speakers

Rear

Test

signal

No Large Small

Exit

Cursor buttons/

ENTER

Subwoofer

CenterMain (L) Main (R)

1 2 ... 22 23 24 25 26 27 28 29 30 31 32

Commentaires sur ces manuels

Pas de commentaire

Yamaha DVD-S1200 Manuel du propriétaire Page 27

Commentaires sur ces manuels

Produits connexes et manuels pour Lecteurs de DVD Yamaha DVD-S1200