Yamaha NHB32-C Manuel d'utilisateur télécharger pdf (Page 6)

FCC INFORMATION (U.S.A.)

1. IMPORTANT NOTICE: DO NOT MODIFY THIS UNIT! This product, when installed as indicated in the instructions

contained in this manual,

meets FCC

requirements. Modifications not expressly approved by Yamaha may void your authority, granted by the FCC, to use the product.

2. IMPORTANT: When connecting

this product to accessories and/or another product use only high quality shielded cables. Cable/s

supplied with this product MUST

be used. Follow all installation instructions. Failure to follow instructions could void your FCC authorization to use this product in the USA.

3. NOTE: This product has been tested and found to comply with the requirements listed in FCC Regulations,

Part 15 for Class “B”

digital devices. Compliance with

these requirements

provides a reasonable level of assurance

that your use of this product

in a residential

environment will not

result in harmful interference

with

other electronic devices. This equipment generates/uses

radio frequencies and, if not installed and used according to the instructions

found in the users manual, may

cause interference

harmful to the operation of other electronic

devices. Compliance with FCC regulations

does not guarantee that

interference

will not occur in all

installations. If this product is found to be the source of interference,

which can be determined by turning the unit “OFF” and

“ON”, please try to eliminate the

problem by using

one of the following measures:

Relocate either

this product or

the device that

is being affected

by the interfe

rence. Utilize power outlets

that are on

different branch (circuit

breaker or fuse)

circuits or install

AC line filter/s.

In the case

of radio or TV interference, relocate/reorient

the antenna. If

the antenna lead-in

is 300 ohm ribbon lead, change the lead-in to coaxial type cable. If these corrective

measures do not produce satisfactory results,

please contact the local retailer

authorized to distribute this type of product.

If you can not locate the appropriate retailer,

please contact

Yamaha Corporation

of America,

Electronic Service

Division, 6600 Orangethorpe Ave, Buena Park, CA 90620

The above statements apply ONLY to those products distributed by Yamaha Corporation of America or its subsidiaries.

WARNING: THIS APPARATUS MUST BE EARTHED

IMPORTANT

THE WIRES IN THIS MAINS LEAD ARE COLOURED IN

CCORDANCE WITH THE FOLLOW

ING CODE

GREEN-A

ND-YELLOW : EARTH

BLUE : NEUTRAL

BROWN : LIVE

As the colours of the wires in the mains lead of this apparatus may

not correspond with the coloured markings identifying the terminals in

your plug, proceed as follows:

The wire which is coloured GREEN and YELLOW must be

connected to the terminal in the plug which is marked by the letter E

or by the safety earth symbol or coloured GREEN and YELLOW.

The wire which is coloured BLUE must be connected to the terminal

which is marked with the letter N or coloured BLACK.

The wire which is coloured BROWN must be connected to the

terminal which is marked with the letter L or coloured RED.

*This applies only to products distributed by YAMAHA KEMBLE

MUSIC (U.K.) LTD.

1 2 3 4 5 6 7 8 9 10 11 ... 43 44

Commentaires sur ces manuels

Pas de commentaire

Yamaha NHB32-C Manuel d'utilisateur Page 6

Commentaires sur ces manuels

Produits connexes et manuels pour Accessoires pour ordinateurs Yamaha NHB32-C