Yamaha RX-V371 Guide de démarrage rapide télécharger pdf (Page 7)

- 7 -

Connect the YPAO microphone to the YPAO MIC jack on the front panel.

YPAO microphone

“MIC ON. YPAO START” appears on the front panel display, and then changes to display the following.

VOL.

SL SR

Press [SETUP]

YPAO

This completes preparations. To achieve more accurate results, be careful of the following when

measuring.

• Measuring will take approximately three minutes. Keep the room as quiet as possible during

measurement.

• Wait in the corner of the listening room during measurement or leave it entirely, to avoid

becoming an obstruction between the speakers and the YPAO microphone.

Press SETUP on the remote control to start measurement.

VOL.

SL SR

Progress 00%

YPAO

Progress

The following display appears if measurement  nishes without any problems.

VOL.

SL SR

YPAO Complete

YPAO

Note

When a problem occurs, an error message or a warning message appears either during or

after measurement. Refer to “Set up the speaker parameters automatically (YPAO)” in Owner’s

Manual to solve the problem, and carry out YPAO again.

Press ENTER on the remote control to apply the results of measurement.

SL SR

Disconnect MIC

YPAO

VOL.

Remove the YPAO microphone.

YPAO  nishes automatically when the YPAO microphone is removed.

DOCK

SETUP

RECEIVER A

ENTER

1 2 3 4 5 6 7 8

Pas de commentaire

Yamaha RX-V371 Guide de démarrage rapide Page 7