Yamaha RX-V1065 Manuel Page 65
- Page / 156
- Table des matières
- DEPANNAGE
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
63 En
Troubleshooting
English
INTRODUCTION
APPENDIX
PREPARATION
BASIC
OPERATION
ADVANCED
OPERATION
E-7:NO MIC The optimizer microphone was
unplugged during the “Auto Setup”
procedure.
Do not touch the optimizer microphone during “Auto
Setup”.
20
E-8:NO SIGNAL The optimizer microphone does not
detect test tones.
Check whether the microphone is properly placed. 20
Check whether the speakers are properly placed and
connected.
10, 11
The optimizer microphone or OPTIMIZER MIC
jack may be defective. Contact the nearest Yamaha
dealer or service center.
—
E-9:USER CANCEL “Auto Setup” was canceled due to an
inappropriate user operation.
Run “Auto Setup” again. 20
E-10:INTERNAL
ERROR
An internal error occurred. Run “Auto Setup” again. 20
After Auto Setup
Error message Cause Remedy
See
page
W-1:OUT OF PHASE Speaker polarity is not correct. This
message may appear depending on the
speakers even when the speakers are
connected correctly.
Check the polarities (+, –) of the displayed speaker.
If they are correct, the speakers work properly even
when this message is displayed.
12
W-2:OVER 24m (80ft) The distance between the speaker and the
listening position is over 24 m (80 ft).
Bring the speaker within 24 m (80 ft.) area around
the listening position.
—
W-3:LEVEL ERROR The difference of volume level among
speakers is excessive.
Recheck the speaker positions and make sure all
speakers are placed in a similar environment.
—
Check the polarities (+, –) of the speakers. 12
We recommended that you use speakers with the
same or similar specifications.
—
Adjust the output volume of the subwoofer. —
W-4:CHECK PRNS Presence speakers were not detected
during measurement with “Extra Speaker
Assignment” set to “Presence”.
Check the presence speaker connections and perform
measurement again. If presence speakers are not
connected, set the “Extra Speaker Assignment” to
other than “Presence”.
11, 46
Error message Cause Remedy
See
page
- RX-V1065 1
- Caution-i En 2
- Contents 3
- INTRODUCTION 4
- About this manual 5
- Supplied accessories 5
- Part names and functions 6
- Rear panel 7
- Front panel display 8
- Quick start guide 10
- Preparing remote control 11
- Connections 12
- Connecting speakers 13
- R) components 15
- TV, or projector 16
- Digital output 16
- (optical) 16
- Connecting other components 17
- MULTI CH INPUT 18
- CENTERSINGLE 19
- Using the VIDEO AUX jacks 20
- Connecting the power cable 21
- Turning this unit on and off 21
- Subwoofer 22
- Optimizer microphone 22
- BASIC OPERATION 25
- Input source name 25
- Selecting a SCENE 25
- Muting audio output 26
- (tone control) 26
- Enjoying pure hi-fi sound 26
- Input source 27
- Sound field program 27
- Program name 28
- Sound field program category 28
- Using iPod™ 34
- Shuffle/repeat playback 35
- Using Bluetooth™ components 36
- Other functions 38
- ADVANCED OPERATION 39
- Sound field parameters 42
- Adjustable range: 0.1 to 2.0 43
- Adjustable range: 0 to 10 43
- Decoder parameters 45
- Connecting Zone2 53
- Controlling Zone2 54
- Setting remote control codes 55
- Updating the firmware 56
- Setting a remote control ID 56
- Advanced setup 57
- APPENDIX 58
- Troubleshooting 59
- Tuner (FM/AM) 61
- Remote control 62
- Before Auto Setup 64
- During Auto Setup 64
- After Auto Setup 65
- Glossary 66
- Information on HDMI™ 69
- Specifications 70
- Precaución-i Es 74
- Índice general 75
- INTRODUCCIÓN 76
- Notas sobre este manual 77
- Accesorios suministrados 77
- Panel delantero 78
- Panel trasero 79
- Visor del panel delantero 80
- Guía de inicio rápido 82
- Conexiones 84
- Conexión de altavoces 85
- R). Utilice 87
- TV o proyector 88
- Salida digital 88
- (óptica) 88
- Conexión de otros componentes 89
- Conexión de memorias USB 92
- VOLTAGE SELECTOR 93
- Micrófono optimizador 94
- FUNCIONAMIENTO BÁSICO 97
- Selección de una SCENE 97
- Categoría Fuente 98
- PHONO, V-AUX, MULTI CH 98
- Fuente de entrada 99
- Programa de campo sonoro 99
- Nombre de programa 100
- FM92.50MHz 104
- Auto Preset 104
- 01:FM92.50MHz 105
- Utilización de un iPod™ 106
- Bluetooth™ 108
- Emparejamiento del receptor 108
- Reproducción de componentes 108
- Utilización de memorias USB 109
- Otras funciones 110
- FUNCIONAMIENTO AVANZADO 111
- Video;;;;;;Off 113
- Parámetros de campos sonoros 114
- Margen ajustable: 115
- Margen ajustable: de 0 a 10 115
- Parámetros del descodificador 117
- Auto Setup 119
- Manual Setup 119
- Sound Setup 121
- Function Setup 122
- Input Rename 124
- EXTRA SP 125
- ZONE2/PRESENCE 125
- Parpadea 126
- Actualización del firmware 128
- Configuración avanzada 129
- APÉNDICE 130
- Resolución de problemas 131
- Sintonizador (FM/AM) 133
- Mando a distancia 134
- Auto Setup (YPAO) 136
- Después de Auto Setup 137
- Glosario 138
- Información sobre HDMI™ 141
- Especificaciones 142
- Índice alfabético 143
- Information about software 146
- Información sobre software 146
- Blu-ray Disc 153
- DVD Recorder 153
- Sattelite 154
Produits connexes et manuels pour Récepteurs AV Yamaha RX-V1065
(182 pages)
Récepteurs AV Yamaha RX-V863 Manuel
(364 pages)
(364 pages)
Récepteurs AV Yamaha MCR-550 Manuel
(56 pages)
(56 pages)
Récepteurs AV Yamaha RX-V365 Manuel
(196 pages)
(196 pages)
Récepteurs AV Yamaha RX-V765 Manuel
(324 pages)
(324 pages)
Récepteurs AV Yamaha HTR-6230 Manuel
(104 pages)
(104 pages)
© 2020, manymanuals.fr. Tous droits réservés | 6.229 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels