Yamaha RX-A1060 Manuel du propriétaire Page 120

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 161
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 119
En 120
HDMI OUT1, HDMI OUT2
Enables/disables the audio output from a TV connected to the HDMI OUT 1 jack or HDMI OUT
2 jack.
Settings
Y
The HDMI OUT 1-2 jacks output 2-channel audio signals when the unit is turned on.
Standby Through
Select whether to output videos/audio (input through HDMI jacks) to the TV when the unit is in
standby mode. If this function is set to “On” or “Auto”, you can use the input selection keys (AV
1-7 and V-AUX) to select an HDMI input even when the unit is in standby mode (the standby
indicator on the unit blinks).
Settings
Network
Configures the network settings.
Network Connection
Selects the network connection method.
Settings
IP Address
Configures the network parameters (such as IP address).
DHCP
Select whether to use a DHCP server.
Settings
Off
Disables the audio output from the TV.
On Enables the audio output from the TV.
Off
(This setting is available only when “HDMI Control” is set to “Off”.)
Does not output videos/audio to the TV.
On
Outputs videos/audio to the TV.
(The unit consumes more power than when “Off” is selected.)
Auto
Outputs videos/audio to the TV. If no signals are detected, the unit is set to the
power saving mode.
Wired
Select this option when you want to connect the unit to a network with a
commercially-available network cable (p.36).
Wireless (Wi-Fi)
Select this option when you want to connect the unit to a network via the
wireless router (access point). For details on settings, see “Connecting the unit to
a wireless network” (p.49).
Wireless Direct
Select this option when you want to connect a mobile device to the unit directly.
For details on settings, see “Connecting a mobile device to the unit directly
(Wireless Direct)” (p.54).
Off
Does not use a DHCP server. Configure the network parameters manually. For
details, see “Manual network settings”.
On
Uses a DHCP server to automatically obtain the unit’s network parameters (such
as IP address).
Vue de la page 119
1 2 ... 115 116 117 118 119 120 121 122 123 124 125 ... 160 161

Commentaires sur ces manuels

Pas de commentaire